1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

231 V6 in 1953 M38-A1

Discussion in 'Early CJ5 and CJ6 Tech' started by Dondo, Jun 30, 2004.

  1. Jun 30, 2004
    Dondo

    Dondo These are my good pants..

    Hutchinson, Kansas
    Joined:
    Jun 26, 2004
    Messages:
    314
    Anyone else has the Buick V-6 installed in a M38-A1? As I've been going over, in detail, everything that has been done to my Jeep, I noticed that I have homemade headers. That is fine for now I suppose, but if they start to rust/crack, I'm pretty much screwed. I looked at Advance online I noticed they had a set of ceramic coated 3.8 liter 231 Buick v-6 headers that claimed they would fit on an M38-A1, but I'm not so sure. That funky factory steering thing looks to be exactly in the way. Anyone have any expierence with this?

    Dondo
     
    Dondo, Jun 30, 2004
    #1
  2. Jun 30, 2004
    sparky

    sparky Sandgroper Staff Member Founder

    Perth, WA
    Joined:
    Sep 20, 2002
    Messages:
    9,221
    Steering's the same as a CJ-5, right?

    Should work.
     
    sparky, Jun 30, 2004
    #2
  3. Jun 30, 2004
    JohnyJeep

    JohnyJeep BLOWING A XING NEAR U@2AM

    Beautiful Cody WY
    Joined:
    Sep 22, 2002
    Messages:
    513
    I bought a set of AA headers for my 4.3 swap into my 69 CJ5 and they didn't fit. :evil: I ended up having to cut out 1 1/2" on the tubes to make them clear the fenderwell. :evil: :evil: I think when they built them they forgot to allow for the 1" offset to the driver side. Just be aware. I now run exhaust manifolds ;)
     
    JohnyJeep, Jun 30, 2004
    #3
  4. Jul 1, 2004
    66cj5

    66cj5 Jeep with no name

    NorthWest Indiana
    Joined:
    Sep 10, 2003
    Messages:
    2,084
    Hedman makes a set the that fit the 225, I would try that route.
     
    66cj5, Jul 1, 2004
    #4
New Posts