Snow Plowing

I am a self taught expert on the E- 47 . We can still get parts . First thing to do , after 7 years , is drain & flush with Kerosene . Remove the & clean the sock filters at the front of the base. The green wire " C " valve & coil is for the right angling . Check that wire for power, while someone angles Right. Sometimes , the coils go bad, but they're still available. Try Stork Plow parts in Bernville , PA. They've got plenty of E-47 parts & are good people.
That's too nice of a set up to not use, IMHO
https://www.storksplows.com
....Richie

 

Possibly frozen moisture in the oil messing with the valve(s). Also verify the electrical connections.

 

Bernville is the one that rebuilt the plow in 2010. and they are the ones who told me. So we will see, it cost me $300 to have it rebuilt, and I was working so I could afford that, I'm on SS now. I purchased a new green wire solenoid and a new motor just in case they were needed but haven't installed them.
The blade sticks to the right when I let it go full right. If I push the left side against a solid object it will release and I can go both ways again. I can go full left without an issues.

 

If that's the Case.......I don't thinks it's your "C" solenoid . It's not your motor , either. Probably gunk & adjustment of the cross over relief valves ( On the Bottom ) . I would look up , perhaps on you tube, on how to do a complete flush . Angling rams & all. Then fresh , blue Meyers oil . I think you just have some gunk in there, from the freeze / thaw conditions . Those two diagonal plugs on the front are where the filters are . Check them to see & then go on from there.
When they rebuilt it .......Look's to me as it's one of the best E-47's I've ever seen. I envy your set-up.

 

So who thinks I can do it?

 

Take Small bites

 

Depends…. Is it powder or mashed potatoes?

 

Today’s big job.

 

2 foot thick ice bass plow berm
4 foot plow berm on top
5 feet of loose snow behind, in a 75 foot driveway

 

Little cuts & start stacking . Low gear. Your Jeeps gonna get a work out .......... If not, your gonna need a front end loader

 

Only got stuck once for a few minutes

she is running soooooooooo good

3 hour job

 

Great job gillafunk!!!

 

When they are like yours......They'll work all day. Keep your fluids , Up . Great Job

 

I'm jealous, we are still waiting for snow. Jeep is ready! The new Snow Boss decals should make it plow better!

 

Oh that is a beaut!

 

Another Strange Season it is on the South Shore of Lake Ontario..........Forecast of 42 degrees on Weds ?

Didn't need 4WD, either.

 

My grand fathers, then my dads old ‘77. It only a had a few years on the new plow before the frame cracked.

 

That’s a bummer.

 

It's a 45 year old NE frame . Weld some gussets on & keep going.