1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

11 inch brake hub

Discussion in 'Early CJ5 and CJ6 Tech' started by piffey263, Apr 3, 2013.

  1. Apr 3, 2013
    piffey263

    piffey263 Active Member

    Medford, OR
    Joined:
    Oct 16, 2008
    Messages:
    1,214
    Been searching for a while and i'm not finding the answer to this.

    I switched to 11 inch brakes on my rear axle, I got the 10 drum seperated from the wheel/brake hub.

    my question is do the drums need to be pressed togeather just like the 10 inch, or do I get new studs and then slips on?

    I wasn't understanding if that is what the swag cutter is for?
     
    piffey263, Apr 3, 2013
    #1
  2. Apr 3, 2013
    Heatseeker

    Heatseeker Member

    Calaveras...
    Joined:
    Oct 2, 2009
    Messages:
    355
    My 11 inchers slip onto the rear hubs on my Jeep. I haven't had a problem with them so far.
     
    Heatseeker, Apr 3, 2013
    #2
  3. Apr 3, 2013
    piffey263

    piffey263 Active Member

    Medford, OR
    Joined:
    Oct 16, 2008
    Messages:
    1,214
    Okay thanks, that's how I have them set up right now.

    I wasn't sure, because the way they looked on hub.
     
    piffey263, Apr 3, 2013
    #3
  4. Apr 4, 2013
    tarry99

    tarry99 Member

    Northern California
    Joined:
    Oct 29, 2012
    Messages:
    3,784
    :)If the backing plates and drums were sourced off of an early 70's CJ you just need to press in studs and the ID hole in the drum should slip right over the axle.........Not sure what you mean about how they look on the hub?
     
    tarry99, Apr 4, 2013
    #4
New Posts