Hi all, I am rebuilding the Dana 18 and I have it all put back together EXCEPT for the rear bearing cap. I cannot get any play out of the shaft to...
I finally got around to testing the drivetrain on my '70 cj5 and for some reason only the t-case driveshaft/yoke spins. No power at all to the...
So I put this together a while back and was waiting for felts/brake parts to finish up. Everything seems to work fine overall until I put the...
Can I use Mobilgear 600 XP 200 oil in my transmission and transfer case? It is a 90 mineral oil. On the MSDS says:"Optimised resistance to rust...
I need to torque the transfer case drive gear after mating my T90 to my D18. Service manual calls for 130 to 170 lb-ft. Where should I hold...
I just finished rebuilding my TC, but it will not be installed for a long while. Any ideas how to go about storing it? Dry, with fluids...? Any...
Where can I find a Dana 18 shim set with different thicknesses? All the sets I've found are all the same shims. I would get that as you fine-tune...
Does anyone know if there is a difference between the shift fork for the front axle with part numbers 18-66-7 and 18-66-8? I need to replace mine...
Does anyone know the dimensions or the dash number of the o-rings for the 1 1/4" intermediate shaft on the D18 transfer case? Thanks!
How is this, speedometer gear (#58), supposed to be installed on the transfer case rear output shaft (#55)? [ATTACH] According to the FSM the...
I've been trying to fix a leak in my transfer case and I've identified 3 sources: Bottom cover Rear output bearing cover Front output bearing...
Separate names with a comma.