Yeah im a cheap skate lol. Sourced this jeep from a pile of used parts some i have had sitting around for ten years. The way i figure it you can...
Well i got the tux up and running today finally. New v-6 running ok still need to fine tune timing and get the idle speed set correctly. But no...
should be available at any auto parts store accel has one for about 10 bucks, Just bought one for my 66 cj
yeah that was kinda my assumption though looks like it was a rather long time ago considering all the grease and accumulated grime in the general...
So i tackled redoing the front brakes on my 66 cj5a and then went to the rear. Ordered all new drums pads and wheel cylinders for the front 10...
I forgot to ask is there some sort of bushing or felt that goes in between the dash and steering column, i have some play in the column because it...
Does anyone have a source for the o ring that goes around the selector part of the hub. Not the small one but the large flat one that serves as a...
I had a revelation, i noticed the vacuum advance on the new distributor has the vacuum port coming straight out of the end of the system, i happen...
So transplanted a 231 even fire and was lining everything up and the waterpump was in contact with radiator. Had a spare short neck waterpump and...
When i lived in eastern washington i decided the stock heater wasnt enough in the winter so i added a secondary heater out of an early 80s toyota...
pinion bearing? When mine went bad caused vibration and noise under load and calmed down when coasting. Aaron
http://www.classicenterprises.com/ they have a ton of weld in body stuff for our jeeps.
I just have to say i wish i had a tenth of the skills to fabricate something. All i can say is WOW.
WOW you have been 1 busy guy. Sounds like you are getting that little jeep ironed out.
When i was younger thats where i kept my beer stash when we went out into the hills, no one ever noticed the toolbox there. Now it is currently...
you guys wanted more pictures so here you go. Enjoy! Aaronhttp://www.earlycj5.com/forums/images/smilies/beer.gif [IMG] [IMG] [IMG] [IMG]...
congratulations. Sounds like quite a bit of work but was very rewarding. Aaron 66 cj5a, 68 cj5 project
the back has ****ty universal trailer lights that someone mounted and crude sheet metal imitations of the diamond plate corners along with a...
All i know if its a v6 flywheel by all means dont drop it on your foot. Dang things way a ton. Mine slipped right off with a little application...
Well since i happened on this jeep for 300 bucks and given that its a tux i wont be using it for parts for my other cj5 as i had originally...
Separate names with a comma.