Thank you. Much appreciated
The Front Axle “in and out” shifter is against the OD in direct drive. Everything is just on center. Just not a lot of room.
[ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Hello, I always felt the shifter was a bit tall but after putting in an overdrive my T-90 shifter gets tangled up in second gear. What is...
Hello, Before I dig in what do you think the cause and remedy would be for a 53 Cj that has a driver side lean or sags a bit towards the drivers...
Thank you! This is why I love this site.
Thank you, thank you!!
Thank you. That’s the answer I was looking for.
Thank you. Just wanted to check with the pro’s before I did something wrong. That was on my mind but wanted to double check.
Hello, Working through a OVERDRIVE installation on a Dana 18 T/C. My question is after removing the cover and nut on the input shaft I’m having...
Hello, Slowly making progress removing a Koenig twin stick front and rear PTO. I’ve removed the five square head 3/8” pipe plugs and then removed...
Thanks again. This was exactly what I needed. Sorry for all the confusion.
Thank you for the clarification. My apologies to the forum.
There are 5 pipe thread plugs that need to be removed from this PTO then 5 Allen screws internally before the PTO can be from the transfer case.
Thank you!
Thank you. That’s the question I’m asking. It’s problematic.
Understandably. That’s the question thank you!
[ATTACH] Hello, I’m trying to remove my Koenig PTO from my TC on my 59-CJ5 to install an overdrive. Of course I have 4 of the 5 half inch bolts...
So you remove the five pipe plugs and the there are allen bolts inside that bolt the PTO to the TC? One other clarification. Can you just remove...
Separate names with a comma.