Hey all, My 75 with a 304 would backfire when shifting or deceleration, when warm. I have re-torqued the header bolts and used special thick...
Did Mickey Thompson make valve covers for AMC V8s? All I ever see is for SBC and BBC engines.
Hey all, I am running a DUI distributor and have been using the supplied gear, but I want to use the gear from the old distributor. The problem...
New Renegade decal is on! [ATTACH]
Down the road I want to add a Eaton Truetrac to the rear axle but also was thinking of adding one to the front. Will Truetrac work on on the front...
Has anyone seen one and what are they going for. I would like to put one back in my 75 if they aren't ridiculously expensive. [ATTACH] [ATTACH]
Hey all, I'm needing to see a photo of the heater box so I can determine if something was cut off mine or just a hole added to blow hot air on...
I am looking for the upper bearing/bushing for my 75 and can't seem to find one. I have the lower but might as well do everything while it's...
Hey all, I am curious as to what this seat might be for. Looking at the fabricated mounting tabs it isn't a Intermediate seat or the mount is...
Hey all, I am kicking around the idea of swapping out the OEM manifold for something like an Edelbrock aluminum intake. Do you recommend the EGR...
Hey all, I noticed that the roll bar hardware at some point was replaced with stainless bolts which are random in length. Stainless isn't any good...
What is the top speed for a 72-75 with 3.73 gears and a 304? Mine doesn't have much after left 60 MPH. I normally cruse at 60 and try to get to 65...
Before [ATTACH] After adding new suspension, wheels and tires. Now I just need to add the Renegade decal on the hood. [ATTACH]
Getting new wheels and tires tomorrow and was wanting to know the torque spec for aluminum slot mag (new US Mag Wheels) wheels. I'm guessing...
I finally got time to get an alignment after replacing the drag link, tie rods, steering box and steering shaft. I get the Toe but is the caster...
Hello all, I am looking for some of the seat lock parts for my passenger seat on my 75 CJ5. 1 - The triangular eye bolt ( Striker, Cushion frame...
Does anyone have experience with Carburetor Center or Champion Carburetor?
Hey all, I was changing out my transmission mount and torque arm bushing to day and ended up having to reuse the old mount. When I put the...
A much needed repair/upgrade is now complete. Waiting on new tie rod assembly to replace bent tie rod and a new heim joint drag link. [ATTACH]
Just replaced the old distributor and installed a D.U.I. distributor with Live Wires. What a difference! It now has excellent throttle response...
Separate names with a comma.