Keep us posted. I'm willing to bet you won't have anymore vibrations.
The painless 10150 harness has everything you need and it supplies a separate ground to everything so it reduces the ground problems.
Interesting. Someone must have corrected the use of aluminum after I ordered mine. Were they 3 degrees?
There are several options but delivered it was $479. X spline, greaseable joints and the 10 spline yoke for the T-case. Just make sure to follow...
I will add this, the shims that came with the Rough Country lift are aluminum and should be replaced with steel shims like the ones from WFO....
Ha Ha!
No, all factory except the springs of course and new shackles to replace what ever the previous owner put on for a lift.
I went with a double cardan shaft and transfer case yoke from Tom Woods. [ATTACH]
Not recently. When I put the DUI distributor in a year and a half ago I set it for 10 degrees. Ibdid checkbit a few months ago. I will have more...
No, luckily
Thanks for all the tips! I have readjusted the idle mixture back to what is should be and it does still rumble and pop on deceleration. Now I will...
From what I can find, 73-79 were the long water pumps. Gates 43002 Here is a good thread on this....
Thanks for the reply. You said, "Remember, those carb mixture screws are JUST for idle.". That's what baffles me, that by increasing the idle...
Hey all, My 75 with a 304 would backfire when shifting or deceleration, when warm. I have re-torqued the header bolts and used special thick...
Most likely the rear will need shims for the driveshaft angle and the front for improved caster. Even with shims in the rear I had to install a...
For what it's worth, according to NTB when I got my 75 realigned. Camber: 1.0 degrees to 2.0 degrees Caster:2.0 degrees to 4.0 degrees Toe: 0.00...
Did Mickey Thompson make valve covers for AMC V8s? All I ever see is for SBC and BBC engines.
KBS has a good top coat rust treatment. https://www.kbs-coatings.com/KBS-Rust-Converter.html or this:...
Here's my 75 with a 2.5" Rough Country lift and 31x10.5 Mickey Thompsons. It did require a double cardan driveshaft. [ATTACH]
Mine has the oil pressure gauge and voltmeter, so if that took the place of the lamps.
Separate names with a comma.