To install a 1971 floor mounted pedal on my 67 cj5 what would I need besides the pedal? thanks all, D
Ok. Good idea…. D
Think I need two…any suggestions? thank you in advance D
What are the dimensions of the original oil bath cleaner? thank you, D
We accommodated that with a second washer…
I found a spicer 2-n-8091x on Amazon that measured correctly..took a chance fro 50 bucks…slipped right in … D
Thanks all for info…the four cylinder Dana 27 yoke has larger and fewer splines so it will not fit…I’ll put up a wtb post. D
My issue is the yoke on front differential is for a smaller ujoint than the yoke on the transfer case.. has anyone found a yoke that will replace...
I used the long input shaft and Novak adapter..everything should be in the correct location…yes it is factory v6 install, just came without a...
Thanks all for input..I need to verify a few things you mentioned and will advise. D
Engine, steering and frame all came together as one unit. Only difference is the adapter and t90…
Standard v6 engine mounts…
Anyone have any luck installing a t90 trans in a 1966 cj5 with Buick engine? we just put the engine -trans assembly on frame and although all the...
Very nice work! Thanks for info…I’m guessing I need to order the gasket set also?
The description at summit says these are fora 231 3.8 engine, will they bolt up to the 225 odd fire?
Anyone have a source for the fitting that screws into the tee? D
Part number appears to be 2122-4
Would anyone have a source for the disk that rotates and directs vacuum to the dampers. It’s in the end of this control panel and has three tiny...
Thank you much!
Anyone have a line on or replacement for the vacuum modules that operate the dampers in the duct? thanks in advance.. D
Separate names with a comma.