So I needed new rear tail lights so I purchase Rugged Ridge 12403.84 Tail Light Kit. So wire properly and the turn signal indicator does not flash...
I am preparing to paint the jeep engine compartment. Is there Dupli-Color that comes close to the Sprue tip green, and is there a place to get...
I have been thinking about replacing my stock fan with a Flex fan. I want to stay away from going electric, for what and where I am driving...
I have a 1968 CJ5 with a Rochester carburetor that loads up and floods intermittently. If I tap the side of the Carburetor, it clears up. I was...
I have just installed a timing chain and I am installing the front chain cover Has anybody just put a sealer where the cover seam meets the pan...
I am installing a timing chain and in the kit is a front seal that is better than a rope, but that's not what my question is do they make a front...
My 1968 Cj5 that was bought new in 1968 has the longest shifter, it has actually two bends in it. It is non- synchro three-speed and it's the...
So all the parts are clean and ready to install just waiting for the Gears Chain Tensioner Gude. So with that new front seal doing away with the...
I bit the bullet and started pulling the front cover I was just about there I just have to take a hamburger break. The one thing I did find is...
This has been driving me nuts. I think I have a timing chain noise at Idle. If I take the engine off idle, the noise seems to be barely...
Separate names with a comma.