do you have mechanical or electric fuel pump?
I was fine coming off the trail but developed this pattern by the time I got home (about 50 miles). What am I up against? Dana 44 rear axle [IMG]
1966 CJ5, stock drive train with Warn OD
lately I've been hearing a dull clunking noise while turning. more when hot after 10 or 20 miles and worse when accelerating through a right turn...
I have a 1966 CJ5 with F134, Solex carb and electric fuel pump and I wanted to put a vacuum gauge on it to adjust fuel mixture and timing. When I...
[IMG][/URL][/IMG] Here is the overdrive shifter between the transmission and transfer case shifters. The cover plate in the middle would...
or... "if at first you don't succeed, try a bigger hammer."
I pulled the original starter and took it apart and looked about like what you'd expect a 50 year old starter to look like. I replaced it with a...
It's done this since I've owned it (year and a half). I think the PO might have moved it around his shop using "starter" power since the engine...
What's going on with the starter on my F134? When I first try to turn it over the starter will give a "grind and spin" sound and then fires right...
I picked up some black base coat/clear coat for the wind shield but I may go with black fleet paint instead so I can match it on the front bumper....
"Spruce it up" was my attempt at humor. I'm not sure if this is actually Spruce Tip Green but I like the color. [IMG][/URL][/IMG]...
Well, I've been driving my 66 around for a little while now and I have to say, it might be the funnest Jeep I've ever owed (12 over the years)....
By the way, I couldn't get my hands on a big puller so here's how I got the drum/hub off [IMG]
Please check me on this: No top anchor pin, shoes joined at the bottom (with a spring), eccentric adjuster bolts = longer shoe lining to the...
you say it ran until you pulled over and then it died? vapor lock? would it start again after it cooled down? how close is the fuel line to the...
I've got a fender from a later model CJ that I am going to shorten by cutting the back off with 1" extra to bend over at a right angle for the...
My fuel delivery configuration is a 1-4 PSI electric fuel pump, Holley 1-4 PSI fuel pressure regulator, Solex carburetor (F134) Question: if I...
ha! i could use the pto winch to reel em in!
Here is what's inside the rear axle. 21920X is stamped on the side of the LS housing. I'm thinking it's a Powr-Loc from the descriptions I've...
Separate names with a comma.