Don’t mind me... just documenting what I did so I don’t forget. Replaced the tank and fuel lines up to the filter. I also hit the tub under the...
Got the new pump on. Pulled the tank to check it and it was nasty. Went ahead and ordered a new tank and sending unit. Also started looking at...
Ha ha, I guess I’ll go ahead and pull the pump then. I swear, I’ve seen at least 5 posts about how reliable the old mechanical pumps are.
Quick question... Got the rebuilt carburetor back on and still no start. I pulled the fuel line from the carb and I’m Getting very little fuel....
Used my lunch break to pull the shifters off. A few observations. 1) the T90 internals don’t look nearly as bad as I expected. I stopped...
Did not think about this at all, so thanks. You’re right, there is a ton of oil on the back side of the backing plate.
Done. Will try to get the trans and case out this weekend. 115AFF69-C014-4D7B-8C2C-4C55602DD665 by Robert Carpenter posted Sep 8, 2020 at 10:02...
Thanks, I did try to put outward pressure on the nut with a little pry bar, but it's still spinning. I might try to put some heat on it.
I figure I’ll start this thread just to document what I’m doing. It’s not really a build or a restoration, but I am trying to get my ‘67 back in...
Wow, that is beautiful! I’m confused about where all the rust is. I mean, it’s only a year newer than mine, so it should look fairly similar,...
Separate names with a comma.