A few reasons. 1)I'm not a fan of locking the D35. I've seen a stock open D35 break an axle shaft on the street. My friend was in the ditch...
Pulled the lunchbox locker out of the D35 (Previous owner installed) and installed a new set of open diff spider gears. [ATTACH] [ATTACH] [ATTACH]
Did the ball joints and U-joints on the YJ's front axle. Was a 2 part project due to finding the u-joints absolutely trashed when I went to do the...
Glad you were able to get a OEM airbox. With the information avaliable now about how poor K&N style filters work I'm suprised anyone runs them...
Well turns out I had far less time than I thought to replace the power steering pump. Good thing I ordered it last Wednesday. By the time I got...
You're going to need an inline fuel pressure regulator for the SOLEX. And it'll have to probably be turned down lower than you think. I have a...
I would have went all the way back to stock height and tire size.
These part numbers are for a 76 CJ5 but should get you in the ballpark. Of course with hard line sometimes the best bet is to bend up your own....
I usually do regular oil analysis on my vehicles. This is the first one I've done on this YJ after doing a short interval change after getting it...
Mission Creep "noun a gradual shift in objectives during the course of a military campaign, often resulting in an unplanned long-term commitment."...
Cheaper than a gearbox overhaul. FWIW I run 15w40 or 20w50 in all my gearboxes since the price of GL4 shot up. T90, T150, AX5. Same for my D18.
On the Jeep front, the XJ has had an exhaust leak tick for a few weeks now. Finally got the time to take it apart and deal with it. Nearly every...
Drove an hour north and scooped up the correct style of steel wheel for this year and trim package. I was about to give up and buy some refurbs...
A couple of days ago, I replaced the brake caliper on the driver's side of the YJ. It was for sure sticking, but it was a little better with the...
crap I haven't posted about the YJ in a while. After replacing the fuel pump, timing set, fuel injectors and exhaust manifold it was running far...
Finished up the timing set installation on the YJ today. I've got ANOTHER fuel leak from the new pump installation. So I'll have to once again...
Finally, got back to work on the YJ. Replaced the rear shackles with stock units and lifted the tank back in. After messing with the connector a...
Nothing serious yesterday, no pictures. Replaced the fuel filter, fuel pressure regulator, left engine mount, which came off in two pieces, and...
Is it a clutch type or gear type limited slip? A torsen gear type wont need the friction modifier.
Apprently welding doesn't help much on these 2.5 manifolds. A new one is 60-80 dollars. I'm just going to pickup a new one and replace it.
Separate names with a comma.