Looking for a usable cj2a frame preferably one before they switched to the 3a style . I'm in Florida but willing to travel if not to far.(weekend...
[ATTACH] [ATTACH] This is on a 1966 dauntless the Jeep seem to run good but it sat for a month and when I started it now it won't idle and I have...
ok I was installing a oil pressure gauge.So I removed the alternator to get better access to install oil pressure line.So here is the stupid part...
hi I'm installing a autometer mechanical temperature gauge in my 225 with a stock intake manifold.My problem is where to install sending unit?I...
are these #'s powr-lok 23209x 1-24-63 C and 23209x 2-15-67 A.If so what gears and spline count?Any help would be appreciated Thks
does anyone have a picture of what the ignition coil bracket looks like on a 1966 dauntless?Does it have one or two holes?And does it mount on the...
I found this setup but was told it came out of a Scout.I have the dauntless v6 with the t86 trans and t18 transfer case.The other setup I'm...
what holds on the left side spring tensioner on?Mine was broken off.Does anyone have a picture of what it looks like?And where can I get one?Thanks
I have a 225 delco distributor in a 66 Tux and went to put pertronix in this weekend.I pulled the distributor and this is what the shaft and gear...
Seen this the ad says its for a dauntless v6 but looks different than the ones I have seen.Just wondering if anyone knows if it is and does it...
Was wondering if anyone had any experience with Rusty’s off-road.Are they any good or should I just buy the BDS spring kit.Thks
[ATTACH] looking for ideas & pics of how to route the cables back to the battery will I have to drill a hole through the side of the radiator...
I have a 66 tuxedo and I'm looking for a self cancelling turn signal switch.I seen a post talking about lens color between blue and green but...
Hi I have the stock Dana 44 with 3.73 gears and was looking to buy a Dana 44 Powr-Lok 19 spline that I was told it was 3.54 gears.But no numbers...
hi going to look a koenig winch from a early Bronco.can it be used on a 66 cj5 it looks like the input shaft is on the passenger side not the...
Separate names with a comma.