Oil temp gauges are normally associated with air cooled engines. I've never heard of one for a liquid cooled engine. I think the water temp gauge...
Some issues that come to mind If you're talking back seat, you will need the support brackets and hardware. Those are unique to M38a1 but easily...
Nice work! I had to do some similar engineering when I changed the wheel style on my wrangler. Speaking of boobs, my wife calls the front turn...
My Jeep had aftermarket replacement axle shafts. They weren't even provisioned with a groove for a snap ring. Weren't the snap rings a holdover...
I use the red stuff in a tube from Tractor Supply. It's like Frank's Red Hot, I put that $#!t on everything. I wash my bearings when I repack...
It sure sounds to me like your commute just isn't long enough to warm the engine. My Dauntless doesn't usually register on the temp senser until a...
My 67 was set up with factory manifolds and mufflers outside the frame under the doors exiting in front of rear wheels. I did not like it. Felt...
Looking for a set of side steps for a CJ. Wanted to see if I can source an original set before I buy Omix. I don't mind if they need repair,...
I don't think that's how the one I worked with was set up. Mine has 3 knobs. Heat / cold which works the door in the heater core, defrost which...
I have the missing cowl side piece. If you need it send me a PM
I might have one of the missing piece but won't be able to check until Monday
Am additional follow up. I got my cable from Deluxe Speedometer. Very high quality item. It's much more expensive than a Crown unit but you can...
I remember reading on a small engine forum about how ethanol very quickly destroys the cork floats some carbs used to use. Is this compatible...
Timely thread. I'm getting ready to do a rear main seal on my TJ and was debating in my head what to use on the oil pan gasket. I'm sure RTV would...
Around here it's about $.10 per pound at the scrap yard. So maybe $250 on the high side?
https://www.facebook.com/share/zgcXm6JXwEDWsV2X/?mibextid=kL3p88
I have mine in at a repair shop now. I'll report back on the results.
I see it now, that was a good explanation, thanks. I worked with my spare speedometer and I see how I want the left hand lay to keep the gear oil...
This is all very confusing. The cable that was on my jeep that I broke was right hand. The Crown replacement which had other fitment issues was...
So after looking again at the CF-100 fork the spring did turn out to be basically the same as the old one. The shape of the fork itself was...
Separate names with a comma.