The hoses are fresh, replaced them when I changed the filters. I swapped a spare coil I had lying around, but that could have been weak. Runs fine...
Yea, well the points are long gone. I regretted that move after the first time the distributor failed on me. Lesson learned. I’m not keen at...
Howard, Same gas station, but I haven’t fueled it since mid-summer. The mowers seem to be running find though….
Wow, thanks for the feedback everyone, much appreciated. Yes, went through the vacuum possibility, no leaks except for the fuel cap (as it should...
Glenn, thanks for your quick response. Checked the fuel pump and line after a stall this afternoon, both cool to the touch. No bubble on this...
I have 64 CJ with the trusty F134. It has run like a sewing machine since purchased. Recently, it has been cutting out when reaching full...
https://www.etrailer.com/Trailer-Bearings-Races-Seals-Caps/Fulton/F001609.html Just a hair small, just need to flare them a bit. I used a rubber...
Would you consider heated seats?
Appreciate the tip on the shims. The bell-crank is a replacement, could be different. After another look, it looks like I might be able to mount...
James, I’m worinh on a similar conversion, same two knuckle. Wondering if you used the stock bellcrank. Mine has a bit of a drop o it. Concerned...
That particular power unit is rated at an equivalent of 500 hp or so, way too radical for a little CJ. Tesla uses two of them in the S model....
Thanks for the feedback. Still working on understanding what it will take. Cost is definitely an issue, but I think it’s the smart play long term....
Less than than my F134!
https://www.evwest.com/catalog/product_info.php?cPath=8&products_id=482&osCsid=3b7254524a839f36c0088b8603b2927b Dyno Graph at bottom of spec sheet.
I know this may be considered heresy among some, but is anyone else considering this? Some of the newer motors are putting up Dauntless numbers...
Got it. I need to brush up on my fabrication lingo!
What’s a powwie?
Who dabbed that tailgate? Looks like it’s stock.
Ordered mine from Kaiser Willys. Bolted right up. See below.
Not a fan of amazon for parts. Iffy returns if necessary. Found that a button head worked for me. Easy start and tighten with a long ball hex socket.
Separate names with a comma.