I have a two barrel manifold off my 74 304 jeep. I am going with an Edelbrock Performer. You pay shipping and it's yours. I'm in Southern Vermont.
Yep, KBS site is cheaper when you figure in shipping.
https://collinsbrosjeep.com/73-81-motor-coatings-engine-enamel-amc-engine-blue/
Thank you all for the information given here. I was given a front axle from a 79 when I purchased a dana 44, to replace the amc 20 someone had put...
I have a 1979, disc brake dana 30 I want to put in my 1974 cj5. I have read the pitman arm is clocked differently on later model axles and the box...
Stock, if I remember correctly.
No, It's an Edelbrock, but the cam is recommended for EFI.
Only second-hand, My buddy installed this in his CJ5 and has been very pleased with it.
Voodoo Hydraulic Flat Tappet Cam & Lifter Kit - AMC 6 Cylinder 199-258 250/256 Expect low to mid torque gains. Excellent for both RV type vehicles...
From what I have read an amc 20 is actually as strong if not stronger than a 44 as long as the tubes are welded to the pumpkin and good quality...
My posting and fonts are terrible. Trying to get better. Never been much on talking. I do appreciate all the helpful suggestions.
THANK YOU!!! That’s exactly what I was looking for. This forum is absolutely invaluable for us in the rust belt. Nothing left here to compare...
Thanks, What I am looking for is if the right angle pc. That frames the tailgate could be removed and that classic panel put in. I’m sure I could...
Hi All, I have a 74 Ren. I am starting to restore. I am thinking MDJuan body as nothing is available for parts in Vt. I want the solid back...
Thanks for the replies, I almost talked myself into the tailgate. There is a homemade tailgate opening now, body has been plated by the PO...
I live in New England’s Salt belt and restorable tubs are not to be found. I am thinking about a replacement tub for my 74 Renegade. Has anyone...
Thanks for the tip, There's a Lou's in Concord, Nh. That's about an hour and a half away.
It cost $240 just to have the muffler replaced on my Liberty! Only one good shop around me, and he knows it.
Thanks timgr, being a Vt. Native hope I never gave you a dirty look as you visited :beer:. I figured I might have to go custom, getting better...
I 'm coming off stock manifolds. I am planning on a mild cam, performer intake, and a TA570 or Fitech throttle body. I wouldn't mind 2 into 1...
Separate names with a comma.