Thank you!! That has to be what it is, I completely overlooked it. Now to go on a parts safari
Does anything belong in the hole shown in the photo? Threaded hole in the passenger side of the block between the motor mount holes and the timing...
87 = Commando C101 05 = Open Body F = Station Wagon (Full Hard Top) 1 = Left Hand Drive 6 = V6 without emissions 7,771 Built, Serials began at...
Jeep/1972/Automatic Trans-Left Hand Drive/Commando 104"/Full Top/3900lbs MAX/304cuV8/5,687th made in 1972.
Hello, I'm in need of a throttle/acceleration bracket for my 225. Is this a part also used on Buick 300, 340, and 350s? Anything similar out...
Thanks Ozfin! The pictures are going to help immensely. Just got a disc dana 30 from a 73 cj5 yesterday. Its a 3.54, so i'll have to swap the...
Here's a few pictures of everything. Thanks! Jeepster Steering
My '66 Commando has a manual steering box and a stock 3.73 Dana 27AF front end. I'm looking to swap it to power steering and to a narrow dana 30...
Its a flanged 44
Rear has been swapped for a 3.73 Dana 44 positive traction I'm pretty sure.
Well now I'm going to have to do some thinking again. Would y'all recommend swapping out my ring and pinions for something like a 4.11 or 4.56? Im...
My bad. Axles are 3.73s. DANA 27AF front and DANA 44 Rear. I'm looking to swap the front with a DANA 30 with discs. Current transmission is a T14....
After some consideration and research, I am thinking about putting a manual tranny in my 66' commando. Leaning towards a 5 speed with overdrive....
Well as of now I'm rebuilding my 225. It only has 42,000 original miles on it and really only needed a valve job. I'm keeping the 225 setup, may...
Well in light of popular opinion, I think I'll just do the th400/dana 20. However a Warn 25% OD unit might be in the mix. Thanks for all the input!
Thanks to those who replied to my last thread, I've got my eye on a TH400/Dana 20 combo at my local salvage yard. I'm not completely set on that...
I appreciate the offer, but you're a little too far away from me.
Thanks for the advice everyone, I've got my eye on a TH400/Dana 20 combo at my local salvage yard. In relation to all this, what about a...
New guy here. I just recently purchased a '66 commando. I'm rebuilding the 225 Dauntless and want to swap the transmission to a th350. I'm wanting...
Separate names with a comma.