A couple of years back I bought a 16" evolution to replace my Dewalt abrasive 'chop' saw - for cleaner cuts and less dust and mess. Well, I...
hmmmmm...Morena Baccarin :beer:
Have you considered a product like 3M panel adhesive?
Everyone knows the bies' drinkin Labatt's is obviously buildin the bester injun.
Grease and grime go in the Varsol bath, rusty bolts and parts get wire wheeled and if of value that need a thorough cleaning, go into a tub of...
Thanks - it was my first welding project after getting a Miller 215. kind of a mix between a welding table / plasma cutting table with the ability...
It doesn't get much worse for me. This is as it sits today, essentially acting as a dumping ground with around half a dozen projects on the go,...
My 55 Willys has a lean....my 2007 FJ Cruiser has a lean...and now it looks like my 2019 ZR2 will potentially develop a lean too...someone, please...
If I was in the market for a brand new carb, I would look at a Weber 2 barrel DGEV. I had one on an 85' CJ-7 after tearing my hair out over the...
Yes, they now work. Thanks very much!
Just picked up this Model 8000 and will follow your build. Wish I could make out the photos you posted though! [img]IMG_8724 by M J, on Flickr
That looks very low Pete. Driver's side I take it? You still running the stock fuel tank?
Sounds like plenty o' love for all three options then. I was leaning toward the Bestop's based on Beachbum's post here: WTB - Front Seats For 58...
Hello all, Looking to replace the seats on my '58 CJ-5. Previous high back seats (out of an Isuzu iirc) and the pipe 'roll cage' have all been...
I did a differential around 6 years ago on a daily driver that still looks newly painted with POR15. The preparation was quite onerous, but worth...
Subscribing to this thread... But also, it should be noted for any Canadian reading through this that duty fees are not charged on auto parts...
in my humble opinion... I have a 58' CJ-5, and have owned it for around 23 years. I've had a few others over the years along with a Disco and an...
Separate names with a comma.