Possibly not a ‘53 as it has a center mount grill vs hinges? Dennis wish mine had been this good looking!
Rear swing axle and reputed roll over prone. wasn't this blacklisted by Nader ? Really wanted one when I was in high school, yard had a few of...
A two groove crank pulley and a two groove water pump pulley please Thanks Dennis
Expensive but it has a high yoke, might work with a Dana 20? Hi-9 in a Ford 9” housing Would be very very short driveshaft though. Dennis
I used a dimple die on my boxed sections approximately every 12-14 inches. Stitch welded the additions, from the frame horns to the rear including...
PM sent
These are what I bought for my M38A1 http://www.canvasco.com/ Post war jeeps tab
Thanks for the offer, got one yesterday in the mail from another member. Sorry should have made a note in the wtb Dennis
No problem, thanks for looking
I have a couple of possible things for trade: 3 groove pulley Or a set of the AA aluminum windshield hold down clamps Or?
Tymbom did this if there were any hot rod places near me I would probably put louvers in the same place [ATTACH]
The housing is plastic, connectors and body are sealed against moisture. Think I bought them from a trailer supplier like:...
I am using these https://petersonlightsandharnesses.com/product/led-stop-turn-tail-lamp-157/ [ATTACH]
Have several 3 groove but would really prefer a two groove in good condition. Thanks Dennis
That rear shackle makes me think of flat springs. If no or little rust it looks to be a quite a time capsule. Too bad it was not available when I...
Jon How much did the vented side panels help with cooling/air flow from under the hood? Cannot seem to find this in your build. Thanks Dennis
I think this is the unit https://www.fuelairspark.com/rpm-module-tachometer-rpm-input-adaptor.html Dennis
Lot of welding on the rear axle tubes and looks like a panhard rod mount welded to front axle casting? Dennis
Tread pattern reminds me of that used on Armstrong TruTracs in the ‘70s Dennis
Thank you!
Separate names with a comma.