Use the rear brake setup. Get a pull up handle assembly from the junk yard, and put it between the seats.
First off, get a good helmet--------the newer electronic ones with the auto darkening are great units. It may turn out that with a good helmet...
These folks are where I would start searching---unless someone comes up with a Jeep specific vendor who has them. http://www.fastenal.com/web/home
Yep, beat me to it.
Did you do the rebuild yourself?? I suspect not by the nature of your question. Maybe you should take it to the shop that did the rebuild ??? As...
Permission granted :D You have already made a number of non stock modifications----------go for the V6.
Do the ones you bought have a metal sleeve around them???
Ted, you must post your photos to a site that specializes in hosting images. I use Picasa, but there are a lot of them out there. Once you have...
Ted, welcome to Early CJ 5 from Cameron Park :D Try reading this for photo help, it is from another forum, but same method applies here....
Did you notice any scuff marks in the old rope seal-----outer surface of the top half??
How was the old seal installed when you pulled the cap off?? Did you have any issues getting the old seal out?
But Howard, I did tell you that about 15 posts ago..........just a slightly different terminology.
I agree that it is most likely leaning out in transition ----------- BUT, that alone will not ignite the fuel/air mixture in the manifold.
Here is my build thread with lots of photos of the tranny and adapter mentioned above, you may find something interesting/helpful in there....
Old trick I learned many years ago, take off the air cleaner, run the engine at 1500 or so RPM, and slowly pour a cup or two of water into the...
Howard, I have to agree that it should be happening all the time, but something has to be igniting the mixture in the manifold. Perhaps the...
O.K., if there is flame involved, something is igniting the fuel mixture in the intake manifold, and it is usually an indication that somehow a...
[IMG] Looking at the above photo, I can see how the wire is kinked to make it go into the attachment block. It looks like the cable may be...
[IMG]
Tim has a good suggestion, try chasing it down. You could also add a vent line fitting to the filler neck pretty easily. Run a line from the...
Separate names with a comma.