I'm in the process of installing a Detroit Locker in my tapered D44. I have swapped the diff out and have the housing back in place. I've run...
I recently pulled my rear axle to install a locker this weekend. When I got it torn down, I found rust. Rust on the inside tops of the tubes, and...
Who makes a decent u bolt flip kit? I'm going to be removing my rear axle this fall to install a locker and powder coat the housing. Due to...
Two weekends ago, I had the privilege of running the Rubicon with the Vintage crew. It was awesome trip as can be read in the post Mortem thread...
I'm putting my rear 44 back together this afternoon. I've searched the forum and found just about everything I need as far as procedure. What I...
Does anyone have the correct bearing and outer race number for the outer on a tapered axle Dana 44? I'm coming up with a couple of different...
I'm adding a rear tank under the bed of the Jeep. After climbing around underneath it with a tape measure, I've come up with a basic size of 17" X...
Omix-Ada replacement or sealer? I pulled my tank today to prep the interior for some kind of bed liner type finish. No big surprise, a leak in...
Like a dummy, I threw out the old plugs that came out of my 231 before the rebuild. I'm trying to get the last few items together to start the...
I'm finishing up a stock refresh on my 231. It came with a Holley 4412-2 500 CFM 2bbl on an adapter plate. The jets are 76's, which I think are...
Not trying to derail the thread, but where would one purchase a Powerlock for a D25? And approximately how much $? Sorry for the hijack.
Does anyone have engine specs for a 231? I'm looking for bearing sizes & clearances, cylinder bore size, torque values, etc. I just finished the...
Is this the right glove box door for my 60 CJ5: [IMG] [IMG] Thanks.
I tore down my D18 transfer case yesterday for rebuild/reseal(it had several leaky areas) as part of my ongoing project(see "Finally got going on...
I finally got started on my CJ5 build. When I bought it, my intention was a total teardown and rebuild for crawling and camping. Nothing too...
I am getting ready to do a bunch of upgrades to my Willy's. I got a hold of a York compressor and I want to mount it up. I'm looking for ideas...
I'm getting ready to do a disc conversion on my '60 CJ5(D25 front axle). I read the article by Steve...
Separate names with a comma.