Does anyone have correct linkage assembly, shift rod, manual lever assy, retainer, etc. I am switching to an auto, got the trans from Novak,...
My 3 speed tranny shifter (mounted on the side) for the convertible is in bad shape. Would anyone know if there is any replacement available, or...
Does anyone have a part number for a 5 blade fan? I’ve seen a number of posts on upgrading the fan, but no mention of a specific fan that fits.
I am looking for some rubber seals for my convertible top frame so the front and rear windows seal. Anyone have any ideas?
Is the passenger seat mount exclusive to the Commando or was it used in other Jeep vehicles of that era? Mine does not have the hook and metal...
First gear is shot in my t86 so I am going to switch over to t90 gears. Can anyone give me an idea where I can buy the entire internals that I...
In the process of restoring my 67 Convertible. I have put the deck lid back in place but I am not sure where the fiberglass pieces go on either...
I am trying to figure out all my loose wires under the dash. I have this wire coming off my light mounted under the dash (light might only be...
Does anyone know of a reputable company that restores speedometer face-plates?
Trying to finish up wiring under the dash, and I have a wire hanging near the heater motor that I assume is a ground. There is a screw that was...
I am currently trying to bring a 67 convertible back to life. Right now I am searching for windows, starting off with the wing windows. I have...
Hey folks, I was able to find a pretty good original clock that mounts on the condole, but it is missing the stem knob. I have searched to find a...
Anyone have an idea where I can find replacement bushings for the original sway bar for a 67? I can find universal ones online, but not sure...
I need to replace my e brake cable. No problem removing it at the transmission cross-member, especially since that's where the old cable is frayed...
Can anyone tell me how to remove the speedometer housing? Do I unscrew the four screws or can I depress the clips held on by the screws. Not much...
I’m trying to take the license plate lights off the bumper to get the bumper chromed. Can anyone tell me how to remove the lights from the bumper...
I'm getting ready to cut out the rot in my floorboard where it meets the riser for the back. Both corners have extra steel spot welded in. I'm...
Can anyone tell me who might sell the rubber plugs for the back of the drum brakes? I can't seem to find just the rubber plugs anywhere.
I was cleaning out the wasp nests in the Jeepster as I prep for interior work and found this in the rear window well. Can someone I.D. this for...
On eBay I keep seeing a gas filler tube cover plate pop up for sale. Is this something that was standard on Jeepsters? I can't find any...
Separate names with a comma.