Alright, well these studs seem to be working. The splines are only cut partway down the shoulder, so the splines only have engagement about 40% of...
Alright... I found some similar studs that might work. The knurl diameter is .667" which might be perfect for a tight fit. My holes were...
Alright, so I'm doing the disc swap in my '69... I go to press the hub/disc assembly together and the stud splines won't engage in the hub. You...
I am currently in the process of designing a york compressor bracket for the 225, as well as a front air tank bumper in Inventor '08. i also have...
Alright, here's my situation. When I let the clutch out to take off from a stop, the whole rig will shudder. It will do this the first few...
Okay, so I'm curious if anyone out there makes (or ever made in the past) a secondary alternator bracket for the 225. I've seen them on SBC's...
bump for new info
Back in December, the Jeep's motor bent a couple valves, and I recently got it back together with rebuilt heads and the rig is running a bit...
try tightening up the bellcrank and/or replacing the bearings in it. i couldn't really understand what you're trying to say when you explain what...
Clutch throwout bearing? Mine makes a lot of noise in neutral with the clutch out. it makes an intermittent clunking noise with a more consistent...
Yeah, yeah... The 225 is supposed to idle rough. how rough is normal? Is it supposed to shake the entire rig? Is it supposed to be a heavy and...
Okay... Is 10* of initial timing too much? Posted via Mobile Device
bump...
Okay, my Rochester 2G carb has one of those filters that look like a tube made out of little gold-colored nodules. there's also a regular...
okay, so I'm on my way to work, cruising along at 65 on the freeway, then all the sudden my engine gets weak. well ... not really all the sudden,...
paint any exposed bare metal. period.
i searched and only found information pertinant to HEI setups... do those numbers still apply to old-school points?
Okay, so yesterday i was bored and tinkering and discovered that my dist. was a tooth off, and the plug wires were all shifted over one spot. I...
drat! foiled again! k, thanks for letting me know.
yeah i wasn't meaning to thread-jack, i figured it was on-topic enough. as an act of contrition I will now insert this carnivorous earwig into...
Separate names with a comma.