I just did this over the winter, I used headman outside the frame headers and had them ceramic coated and installed the dynomax turbo mufflers...
The parts manufactured for the points distributors are not what they used to be either. I used a pertronix and never looked back.
Same here I purchased the same one and and it worked for about a year and a half or about 800 miles. Where the throttle brackets mounts to work...
Sorry for the slow reply I’ve been very busy. Right now I have a replacement aluminum radiator installed 1 year ago closest size I could find to...
Is love to get the proper shroud but they are hard to find. I suppose I could set it up as a pusher and keep the mechanical fan. I believe I do...
Anyone else out there running an electric fan set up with the larger radiator on the v6? I was thinking about getting rid of the mechanical fan...
Is that Saginaw conversion done with leaving the factory front dump drivers side exhaust manifold?
I’m not trying to hijack your thread, I have been looking at these exact headers for my Saginaw swap. Are you able to connect the muffler directly...
Tomorrow I’m going to try and pull the fill plug in the 18 drain out the excess, leave the plug out and fill the t14 until it comes out the top...
That’s what’s happening here becuse I took the fill plug off of the transfer case to top it off after it sat for 2 weeks and leaked all over the...
I do remember that I think I used sta-lube last time
I have a cj5 with a t14 and a Dana 18 T case. My question is what the correct way to fill the transmission with gear oil. I know the trans and T...
Search metalshaper on YouTube he has a video on the set up for “end play” in the tapered axle
I didn’t upgrade to a different distributor I still have the crt performance hei, but I put a new vacuume advance that has a 90 degree bend up...
Fino cj you have a good point it could be leaning itself back out at idle. I took a carriage bolt cut it of and filed the square part ontop so it...
So I took fino cj’s advice I sprayed around the intake and carb base with carb choke cleaner to look for vacuum leaks. I didn’t find anything...
I will take the carb off tomorrow, I’m pretty sure they are 51s. I have a brand new set of 53 laying around think that would a mistake skipping...
I have a 160 thermo depends on what kind of driving but somewhere around that 170 180 If I’m putting around fire roads on the interstate which is...
Okay thanks, is that a common problem with todays gas?
I apologize I have to change the post I meant to say lean
Separate names with a comma.