It is rusted between/around the layered area (of course, what a bad design). My friend that is in the bodywork business thinks I should just...
Well the jeep mostly drives now. Its a 1974 with the 258. It has always felt slow relative to the 79 (which also has a 258). Today I drove it to...
The first thread was mostly me complaining and wondering if I missed the obvious. Anyways... I took it apart again today and I think I found the...
I don't even know if I care to fix it at this point, but I'd like to see if anyone has had similar experiences or if I'm doing something obviously...
My choke heat pipe broke. I could make a new one, or throw on one of the manual choke kits. Thoughts? Pros and cons? '74 258
This one should be easier than the floor drains you guys helped me with :) It should be the last of this too! Anyways I need to know where the...
I've read a few horror stories. I'm completely stock electrically, but is there anything I should do to improve the safety of the ammeter system?...
If all goes well I'm going to be starting up my project after it being dismantled for a year and a half. Before I took it all apart I fogged the...
So our rear mount gas tanks are mounted at 3 points; the two in the back corners, and the one centered up front. My question is if anyone has had...
I'm looking for measurements on both the size and placement of the factory floor drains. I didn't document this and the old metal is long gone!...
I'm wondering if the axle shaft has to be pulled, would I damage the bearings or anything driving the old stud out with an air hammer?
Things are coming together and hopefully I won't have too many questions like this. Do the bolts that hold these brackets on use lock washers or...
I need to buy some more to get this thing back together. The bolts I have (likely factory) are marked with nothing but a triangle. What grade were...
Am I able to take the cover off without messing up the adjustments? I'd like to remove the old grease before putting new stuff in. Happy Easter...
I'm doing a front disc brake swap and the bracket is pretty beefy. New studs came in the kit, I'm sure they're longer but I'm hoping to get by...
Mine is welded the crossmember, and bolted. Is this factory? I'm suspecting it isn't and want to have the draw bar powder coated.
Just a quick question. I'm gonna be adding a 4 pin connector to my '74, I'm assuming I can just splice it in but I wanted to check. EDIT: I...
I feel like everything I do needs to be philosophically consistent or a package deal. I appreciate the simplicity of a CJ, should I stay...
Mahindra wins IPR case against Fiat Chrysler in US, can now import Roxor SUV It's a shame there was a lawsuit to begin with.
The guy that's doing my floor pans recommends undercoating the entire bottom to prevent chips if I'm gonna off road it, I'm thinking about only...
Separate names with a comma.