Thanks Uncle Bill... Robert @ dataplates4U.com has data plates for many Willys models, however not the CJ5 type. If I come across a good...
Cool... Thanks for this, it's quite simple and I appreciate the "look". I'll keep looking for a replacement, and a vendor who may supply "like...
Thanks!!! Excellent link!! Now if someone would happen to have a photo of the data plate (serial # for vech) I'd appreciate it... I plan to...
Hello All, Can anyone send me a photo(s) of their CJ5 ID plate? Roughly the 1955 to 1960 variety... I've got a 1958 and need to know what the...
Kaiser Will & Modified, Thanks... I've got the engine on a stand, and just removed the nut. I'll PB the pulley overnight and try as you've...
All, I plan on replacing all gaskets on the 134 B-4 re-installing.. so my question is pulling off the the crank's pulley. Will just a gear...
Kaiser-Wil, Thanks for that clarification... On e-bay I saw a CJ5 with a bench seat, (it was a modified mini-van back seat)... looked pretty...
Hello All... I think this topic brings to light some needed information (especially for myself) the "matching" of flywheel ring gears with the...
Kaiser-Wil, What seat does your suggestion replace? Drivers, Pass, or a rear seat? I'm about ready to start looking, so I do appreciate the...
Jim... Excellent!!! Those are priceless! Thanks, Joe in Jersey
Hello All, I'm putting the CJ5 back together (1958) and would appreciate photos - illustrations of the return spring attachments/placement for...
Birddog, Thanks for the advice... I'll do as you suggest; and I'll read up on that knuckle pull. I feel confident it'll be OK. Joe
Hello All, I needed to remove the 4 bolts on the upper bearing cap of my 58 CJ5. For one thing they were all rounded off, and for another I...
So I guess I need to determine the ratios of each axle... the "25" and "44" only indicate the size(?) and model??? I can open them up and...
Hello All... On the 58 CJ5 my son and I are working on, the front axle is a 25 and the rear is a 44. I've heard the front and rear have to...
Hello All, Nice job on the frame and YES, way cheaper than powder coating. I've been looking at this product and others for a while now (you now...
Good Morning CPO, Thanks again for the info... No confusing, since I'm still in the "thinking/trial" stage. I guess I need another tee or...
CPO... Looking closer at the photos (#2) it appears that the brake line runs through the frame?? I found the holder which Schlink referred to and...
CPO, The photos do help, thanks! And the stop light switch I have screwed into the very end of the Mstr. Cyl. In between the MC and switch is a...
Shlink, Yes this does help... as confirmation that one of the tubing pieces I have remaining does fit on the front (HA!). I'll look for that...
Separate names with a comma.