Putting new floors and cab supports in my 64F100. Mike E5D5AAAC-0AA5-4947-8824-0B45ED19DAF8 by BadGoat posted Mar 23, 2023 at 10:49 AM
I used two smaller fans to move the fan motors away from the center of the engine. This helped with the clearance. I don't have a fan shroud,...
You can put the intake behind the dash, lots of hardcore trail rigs do this. However, it is very noisy. I need to do an update video on the...
I ended up shaving the the back of the headlight buckets in addition to the grill shroud. Then I used a set of cheap super thin LED headlights...
Steering and cooling systems were the trickiest parts of mine. The LS motor mounts and the shorty headers don't leave much room for a steering...
I did mine by myself, so you don't need two people to do it. The u-joint does not hold the bushing in place and the shaft can be cut more than 1...
I like that you kept the old speaker grill. Mike
I I don't know how much travel it has on the splines. They just wanted the measurement at ride height. I'm also using a Dana 18, but haven't...
The length of the pitman arm should be approximately equal to the distance from the center of the ball joint/kingpin to the center of the drag...
My double cardan driveshaft from Tom Woods is only 14 1/2 inches long. It works just fine, even with the LS providing way more power then the...
I'll add mine as well. I converted my bell cranks steering to power using the following. Advanced Adapters conversion kit to allow use of the...
For those doing the in-tank fuel pump with a rear mounted tank, I highly recommend cutting an access door in the bed, over the sending unit. At...
Here's a good reference on what should be included in the plumbing. https://mbmbrakes.com/proper-brake-system-plumbing/ Mike
This was posted before, but the link has changed. Here's the correct version for the locking tab washers. FWIW I'm running the old style...
My company is called Bad Goat Off Road. Add a .com and you'll find the website. I sold a bunch of ropes when I was up in Alaska, but haven't...
The old timers will already know this, but the info might be useful for someone. You can put together an easy field welding kit by simply adding...
Separate names with a comma.