I like it, it looks a lot like my old Buffalo drill press!
Manual says Vertical Mill and Jig Borer. It does not have a power feed, but I can do the small work I need to do. [IMG] [IMG] [IMG] [IMG]
Had to slow down some, quad bypass. Mule work has slowed down a lot, but I bought a 1964 CJ3B that is near perfect that I am piddling around with,...
Nice work, Mike. I just realized who you are, you came down to Springville a few years ago and helped me get the gears on my 9" South Bend...
[IMG] Is it just me, or does the belt look misaligned?
Normally, I don't care for the heavily modified vehicle threads, but this project is very interesting and I am enjoying following the build. I...
I'd say add the receiver, too. Now's the time to do it, and I don't think it will take away from the look. I assume you are going to add the Rover...
I enjoyed your photos, but I know it's a lot of work to restore them.
That would be my guess. Be sure to carefully inspect the fork and pivot ball.
I like to pull the engine and leave the bell housing, transmission and transfer case in the jeep. I find it much easier in the long run and almost...
The surprise is that the engine didn't blow up. I and others ran it to test drive it to buy it, and we ran it 4 hours to bake the engine paint....
FWIT - there is an oil spray jet that screws into the front oil galley and provides oil between the cam gear and the crank gear. If this plug is...
Has anybody followed up on this on the CJ3B page? Jeep Fuel Gauge Tech Tips on CJ3B.info "Greg Wilkens in Australia installed VDO instruments...
Thanks. At this point, I will probably relocate the two aftermarket gauges to an under-dash mount so I can go ahead and repair the holes in the...
I have been following your thread with interest, especially your work on the fuel and temp gauges. I have a 1964 CJ3B and the cluster mounted fuel...
Separate names with a comma.