Usually you only need the common wear parts to do a rebuild, unless you have a damaged or severely worn gear or gears, etc. Even those will often...
Also available at Walcks https://walcks4wd.com/e-cable-clip-to-t-handle_p_674.html
I believe it is a Dandelion removal tool. You drive it in down along the root (they have a long center root), then pry/pop it out of the ground....
I used the NuMetal epoxy putty from KBS Coatings, worked great. I think JB Weld makes a thick dough-like putty too... [MEDIA]
There should be no relationship between the thickness of the spacers and the thrust washers. The spacers only set the space or roller "end-play"...
Very nice. I have a good reliable blasting guy here too, very reasonable and worth every penny. If you ever need radiator work in Houston,...
I found metalshaper's videos quite helpful, he has several on the front axle... [MEDIA]
Nearly the exact same story here. While I haven't run it yet either, I am confident it is correct for the application, he knows his stuff.
I adopted this several years ago too because it made sense. When torqued down wet, you basically squeeze the sealant out. If you finger tighten,...
There is a guy playing a banjo on a porch swing where that thing came from!
Not sure if these are exactly the same, but I did remember seeing these complete kits while looking at replacement tubs... MB COMPLETE MASTER...
The rear part of the cage looks similar to a Smittybilt roll bar, but maybe slightly different? The center one in this pic is a Smittybilt, (still...
I used a Rustoleum epoxy kit from Home Depot. I followed all the steps, it went on nicely and has held up well to a wide variety of abuse. As...
If the groove isn't too awfully deep, it may be salvageable. A good machine shop could tell you, likely chuck it in a lathe and polish the surface...
When you take the old pump off, good to inspect the camshaft eccentric that drives the pump for wear. They are known to get a big groove worn in...
I may have done this too, it has been awhile. I definitely did (and recommend) this. I had my press all set-up to go, got the frozen mainshaft...
If you get Novak's rebuild kit, it comes with the upgrade sleeve to replace the problematic snap ring. Also, you might consider the 3rd gear...
I rebuilt one including the shift tower, the third gear upgrade and installed Novak's Dana 18 adapter kit (mainshaft and adapter plate). The...
Separate names with a comma.