Okay guys. In another post, I asked if the rubber ring that's in the harmonic balancer was any good. Truth be told, I went over that son of with...
I read that it’s not an easy part to obtain for my year/engine due to reproductions holes not being aligned. If I didn’t need to replace it then...
CJ5 1974 258 i6 Hello Jeep lovers! I was working on the engine and I was removing paint from it and when I got to the harmonic balancer and I...
Blasted the valve cover with garnet sand and cleaned ready to be painted! After a little repair work on the bolt holes.
What book are you checking?
I’ve read somewhere that using a nut driver tightened by hand is sufficient torque. Is there any validity in that statement?
I’ve cleaned up the valve cover for the 74’ CJ5 AMC 258 l6 and was wondering in this picture I have attached. Does this bolt hole need to be...
The backlights worked as far as I can tell. It has been a couple of years since I last ran the jeep. Currently, I’m working on it doing a frame...
Not sure if this will help, but I have a t18-1b here is a picture of what mine looks like
Thanks you guys!
howdy folks it’s been a while since I’ve been on the site. I have made it to the point of this rebuild where the engine is ready to go on the...
Ran into the same issue when changing out my leaf springs and shackles. Used a center punch to fold sides in and a cold chisel with a hammer and...
Yeah haha I would have never check emissions section of the manual. Thanks Tim
Yes the one with 2 prongs is the back up switch. The other says on the wiring diagram just "transmission controlled" both end up at the ignition...
Ah great. I haven't checked the wiring diagram yet on the TSM going to give it a look over. Thanks for your thoughts!
Hey guys I was cleaning up the transmission and I saw a couple items I did not recognize. I went pouring over the TSM and had no luck finding out...
Thanks for all the help guys! I'm new to finding parts and the whole jeep restoration project, but I am determined to learn and ask when I cannot...
I have another question but this time it is about the lens for the brake lights. Does anyone know where I can get a replacement brake lens that...
Yeah i have read on a few threads someone smashing theirs. I'm not going to be off roading much if at all here in the desert. When the weather is...
Thanks everybody for the replies! I do believe I'm going to keep it stock. Maybe think about putting in an upgraded bulb to give it some umph!
Separate names with a comma.