The lug nut holes on my aluminum wheels are too small for the aluminum wheel type lug nuts to fit in (see picture). They do have bevels on the...
Anybody know how to get the shaft out of the adapter? I've removed the snap rings on both sides. Do I just press the shaft out to replace the...
I want to swap my worn out SM420 for this NP435 that is for sale locally with adapter for $300. I've seen this exact adapter on an NP435 before,...
I've had enough of these cherry bombs, would really like to get my Dauntless at least 50% less obnoxious in the noise department. Like all of us,...
I have a lot of noise from my D18 and I don't like it. Also it gets hotter than it should at the rear bearing cap where the rear driveshaft...
Anybody have a picture of how they made the connection between the shift rods and the stick mounts? [img]
I don't want another Omix deal, two of them have broken on me and it's a giant nightmare to change them. Is there a good brand of clutch fork? [img]
Question. Is this winch worth putting any effort into? I have this winch that was on my Jeep when I bought it. I've never used it but I am pretty...
Vortec V-6 engine motor Says some things were damaged during removal. I can’t tell what’s bent or how bad. Any trained eyes know if this looks...
@NeedsRusteze74 just bought this NP435 with a cool adapter for the Dana 20 tcase. I believe that's a Chevy bell housing so that's gotta go. This...
Moving my locker and gears over to a new axle but I can't get the yoke off the pinion splines. I've tried the 3 jaw puller with heat but I bent...
Is the bearing and bearing retainer that is pressed onto the axle shaft all that keeps the flanged axle in? On my axle I slide the bolt plate on,...
Thought I was being clever, did all my research and determined rotors off a Dodge Ram 1500 were the correct bolt pattern and had a large enough...
Goals: 54.5" WMS to WMS offset rear D44 (would allow me to eliminate my wheel spacers) Flanged so I can dump the tapered axle 19 spline so I can...
[img] I put the drum on backwards to use as a slide hammer and it just wont budge. Am I doing something wrong, is there more to remove than the...
Is there a difference? Will ECJ springs work on an intermediate or are the intermediate front springs longer? Thanks
So I pulled my diff cover off to start investigating my locker situation etc. And look what was in there. [img] [img] [img] [img] [img] But...
I have a really nice Best top soft top that I've taken all the windows off of and want to make it a full length bikini top that offers shade over...
So after a short drive around the neighborhood last night, I noticed my power steering box was really hot. Hot enough you couldn't hold your hand...
New power steering setup. When I start the engine it steers all the way to the right all by itself. It does it with some real force and keeps...
Separate names with a comma.