About to start replacing the lines in my 68’ CJ5 with the 225 V6. Looking in the manual the lines appear to go over the engine. Current lines...
Thanks for your replies. My dad already bought the new tank, so I never got a chance to look into having the existing cleaned and repaired. The...
Searched but couldn't quite find the answer. We are replacing our fuel lines, tank and pump on our 68 CJ5 with the 226 V6. After talking with...
Follow up on this. Just finished up with installing these. It certainly stiffened the steering but not all the way. Am I likely looking at...
Sounds good, just heard back from KaiserWillys, they are pretty sure I was sent the wrong part and are express shipping a new one free of charge....
Thanks I'll give that a try.
Have the front axle taken apart minus the carrier. For some reason we can not get this to come out to get to the inner seals. Any tips on...
Got around to replacing the tie rods yesterday and the passenger outer that I was sent is too large for the tube. Am I missing something or was I...
Thanks for the help guys. Got the correct ones installed on Wednesday. Now the trouble is getting the yoke off at the front axle. All of my...
Looking at replacing the U joints in my 68 cj5 v6. I see at some auto parts stores that they are the same front and rear and different in other...
New brakes just came in, new brake lines as well going in. Next will be looking into a transmission brake (parking brake).
We were looking at adding a parking brake to our 68'. Reading the service manual and see that oura came with a transmission brake instead. The...
20190925_073108_HDR by Jeremy Knakmuhs posted Sep 25, 2019 at 7:56 AM The new puller you recommended Focker worked perfectly. Just needed a...
Sorry about that guys. I'll be sure do check the folders better when posting.
20190921_142037_HDR_resized by Jeremy Knakmuhs posted Sep 21, 2019 at 3:07 PM Got the new puller (and nut back on). Lets hopebit pops off this time.
Thanks as always guys. Started with the rear axle figuring it would be the easier of the two. I will get a different hub puller ordered. All...
Yes, we switched to the Grade 8 hex head bolt as the one that came with the puller stripped out. We will try again with some heat and see what we...
Sorry, here is the picture.
Have a hub puller from Advance on there now. Nut is off and have cranked as much as we can with a breaker bar. As yes, plenty of swearing along...
Separate names with a comma.