My 71 was doing something similar. What it turned out to be was that the lower choke linkage was sticking out too far on the fast idle cam and...
On my 71 the bottom outlet is straight like the one shown. I was wondering if it was a direct if, or if the brackets had to be modified.
Had anyone ever tried one of these?? If so, how did it fit? [IMG]
I adjusted the spring as Walt instructed, and have not experienced the problem since!
Thanks. I did realize that had an adjustment. I'll try it.
I have a stock 1971 cj with the dauntless V6. I've been having an intermittent issue with the Rochester 2G carburetor. Occasionally upon...
Thanks to all who provided their assistance. However, they couldn't get a diaphragm clutch to work, so again I've got a rebuilt three finger...
So, I assume that there are raised and not raised (flat) diaphragms? I'll check with the shop to see which one they have.
Not disengaging.
I found the below info on this bulletin board: Buick V-6 clutch lever and throw out bearing (CJ3B Bulletin Board) Most Dauntless CJ's were...
I'll call them Monday morning.
My jeep is completely stock with the original clutch cable, not a hydraulic conversion. Though I am no mechanic, it would seem to me that there...
Thanks. I'll pass that on to the shop. Has anyone experienced this problem with their 71, and can verify what the issue is, and provide any part...
I've had my stock 1971 V-6 CJ5 since 2009. I tried to have the 3 finger clutch replaced with a diaphragm clutch years ago, but the transmission...
My 1971 cj Rochester 2G requires a dashpot. The original was worn out, and when I tried running it without it, unless I had the idle set real high...
I got a direct replacement from Summit Racing for my 71 (Ready Aire 399204). The inlet and outlet are both the same size....
Delco10si 63amp, connection @ 12 o'clock ac delco - 321-43 NAPA- 13-4011A Oreilly Auto - 01-0043X
I swapped my Rochester 2G with these guys. All I had to do is set the idle speed. The jeep runs great, and there's a lifetime guarantee....
I used a paint brush on everything, including the valve cover. I stripped all of the old paint off of the valve covers using a wire wheel on a...
The POR paint has held up well. It's been on the engine for 2 years. Absolutely no chipping or flaking on the engine. Had slight flaking on a...
Separate names with a comma.