Everything is new, carquest is where i got box, but i think they all deal in the same rebuilders, ran it through a top notch line up shop, the...
Does anyone have experience with AGR steering boxes? Auto store rebuilds have too much play.
I have seen those, also found offset inserts for upper ball joints. Summit.
I haven't been able to find adjustable or offset ball joints for a cj....thanks, I'll get problem solved one way or another.
I hope your right.
everything is new, ground up rebuild, starting with the sandblaster.
top of tire is leaning out, noticeable if I look close enough, steering weaves, going to line up shop later in the week. I wanted to check sleeves...
How about the torque on the sleeve on the upper? and torque on the nuts?
What are my options for adjusting camber on a dana 30? ...1977 cj5.
Got it, it was the brand new omix gauge cluster, gas gauge was defective. Luckily 4 wheel parts took it back, thanks.
Ok, I removed sending unit on gas tank, hooked it back up and moved float by hand, in down position it reads empty, start raising and it goes...
both the oil and gas ,do not do anything with sender unhooked.
The wires test good and I even ran a temperary one to double check, and I get the same result...Full...I took sending wire off tank and grounded...
No I did not test.
I think Omix, but I hope I wasnt missing something simple. everything was ordered for a 77 cj5, so it should match, I agree with crown a Omix...
77 cj5 , new tank, sending unit, gauge cluster, wire checks out fine, when the key is turned on it goes to full and stays there, grounds are...
Good friends with my local carquest, after an hour long search, they are sending my old one out for rebuild.
New waterpump on 304 is about 1/4 to 3/8s longer than old, added pully and it is too shallow to line up with the rest, belts wont run like...
I have a 77 cj5 with a T150 3 speed, Iam putting a 1974 304 in it. I can not get the bell housing and motor all the way together. lacking 3/4 of...
Separate names with a comma.