I just acquired a hard top last week. It’s either a Kelly, or a Meyer. It’s missing the fill in pieces for around the windshield and missing the...
Ok guys I bounce something off of you F head guys? I have a bad miss and loss of power in my F head when you are at cruising speed and engine is...
[IMG] I'm needing this turn signal switch for the 77 postal column in my 5 Would anyone know where I could get it any cheaper? a 100 bucks is a...
Does anyone have a part number for a brake pressure switch? one that goes on the master cylinder, for my 62? thanks guys.
I just acquired a set of Clifford headers from a member here. With plans to put them on my JEEP But tonight I was doing some measuring and...
I was in the middle of cleaning up my transfer case and cracked one of the bolt holes on rear output housing. No worries I had a spare. the spare...
[IMG] I got one too! I have a friend who makes decals on the side and he made one for my ole JEEP. Matt gave me the Idea for it. Been wanting one...
http://www.quadratec.com/products/52114_09.htm Do any of you guys know if their "ORIGINAL REPLACEMENT PARTS" are made by Crown or Omix ADA. And...
[IMG] Hey guys, Have you ever seen this? I was starting my t-90c conversion on my 62. the longer input is the one I just took out of my t-90a...
http://www.autozone.com/autozone/parts/Duralast-Ignition-Conversion-Kit/1962-Jeep-CJ5/_/N-izg8uZ9n9i6?itemIdentifier=518075_415035_0_ I was...
Working on another F head and was looking at the rod bearings FM 9955-SB [IMG] I assume these are a standard size...
Ok guys school me a little here. I am tearing down the t90 that Stout gave me. the case has the typical t90 a1 on the side [IMG] Now when I was...
I was thinking of changing out the freeze plugs in the F head I'm rebuilding. My question is they look different than most modern plugs I have...
Did a quick search and couldn't find anything. My numbers on this F head is 4j407346 Or tell me where to look it up at. Thanks guys, Jason
Are the Dana 30 spindles the same as the 25/27? Johny Jeep has a set...
In Stouts post I think I broke my engine, garage gnome relied about melling oil pumps breaking. "Be leery of the new oil pumps. On the 2A...
What if any difference is there in these oil pumps minus the direction of the gear? It says it depends on the vin number my last 5 on mine is...
Hey guys, I'm stuck! A few years back I did a snaggy swap on my 62 and used a 76 postal jeep column. well the switch is going bad and I can't...
I have been working on these off and on for the last few days, And wow what a difference. The whole jeep has a tighter feel, and rides a little...
Hey guys, I'm going to have to rebuild/or get a new oil pump for the 62. I was wondering what would you guys do buy a kit and rebuild the one...
Separate names with a comma.