Looks good man, can't beat the price on his cage kits. John
Shipping quote to 85741 for the front diff cover??? That looks sweet, I might just have to copy that.
Looking good, thought you disappeard.
dbender, The e-brake is a bit obstructed but I am still able to set it. I just have to twist my foot a bit to get it down. John
Mine did this as well. Part throttle, had a spot where it would fall on it's face almost put you through the windsheild. I pulled the power valve...
How's this? If you need more shoot me your e-mail and I will send you some. John [IMG] [IMG] [IMG]
Gotcha. I will get a pic of that area with a tape measure when I get home tonight.
Can't remember how much I cut off, but it was at least 6 inches. Long end of cut to top of hoop looks to be about 32 in. Hope that helps. All of...
My was all .120 thick. You could probably get them to sell you a length of 1.5 od .120 wall tube for triangles above as well. A 10 degree cut on...
http://extremecustomparts.com/c-69051-roll-cages-roll-bars-add-on-kits.html Shipped to my door in 5 days.
I didn't bend the tubes, it was a pre fab kit. I just changed the design of it and added some more tubing to it. The boy and I just went for a...
So after putting this off forever and a few close calls I finally got around to putting in a full cage. Plus my son is riding in the jeep more...
Yeah mounts are all done, and the trail rack is in rough form but pretty much done. Kind of over built the jerry can mounts, used 3/16 plate and...
That is the same article I used to rebuild my Dana 44. First time doing gears, I was a little nervous about it. 3500 miles later and they are...
Do you have the new exhaust donuts yet? Hard to explain, but look at the gasket in the picture.. http://www.quadratec.com/products/51404_03.htm...
So it's finished for now. Added a cheap tractor light for backup, and bought some new shackles from a local vendor. The pull pin I bought from...
There isn't really a place to drill through the latch for a pin. I just ordered a pop pin from Graingers for a hold open mechanism, I might set...
Bumper and carrier done for now. Just need to paint the carrier. I plan to make some Jerry can mounts and make a rack to go above the tire. I need...
I used the grade 5 I believe from Lowes/Home Depot and 3 of the heads of the bolts broke off. I replaced all with grades 8's and lots of...
Made some progress. Bumper is about done. Just need to weld up a stop for the swingout and paint it. Swingout is taking some time, need a new...
Separate names with a comma.