I hate to add another option to the mix, but my Holley Pro-Jection system works just fine on my 225. The only complaint I have is it throws too...
Check the posts. I just went wheeling again today with my Pro-Jected 225. Works great!! Contrary to the Holley engineers it can be done!
By the time I'm done messing with my Dana 44 I'll have over $2000 in it alone. I've got the FF kit, New bearings, Ordering a ARB later this...
If you do use the Novak kit make sure they give you the updated instructions. I fought mine for over a year before I found out the endplay specs...
Overhead welding is a learned teqnique (kind like spelling). I used to clamp a chunk of plate to my welding table and lay on my back to practice....
I always add some grease to the cavity. I don't pack it FULL but I do put a bit in there. That way it'll flow (as well as grease can) when it's...
I've got a set of 19spline axles from my 67 that I'm going to be getting rid of if you're interested. I bought the Warn FF kit. Went...
A guy could get beat up around here for doing someting like that!
There is usually a reason they slide forward. The dogs are held in place by a spring/clip from underneath (from what I can remember). I'd bet...
I removed my glovebox to mount an extra heater. I mounted the ECM on its side right next to the heater. Makes a clean install and its easy to...
Might be a broken shift dog or blocking ring?
DONT FORGET to put silicone on the bolt threads when you install the adapter plate. The holes go through the back of the trans and will leak...
You should be able to spin it by hand in all the gears by grabbing the input shaft. If not I'd say there was something wrong. I would pull it...
If you've got hanging pedals and don't mind a little fabrication I'd go with the Wilwood style from Summit that pulls rather than pushes. I LOVE...
What is your endplay set at? I bought a kit a couple of years ago and had lots of nagging problems after the install. I contacted Eric at...
Sounds like excessive blowby. You did hook up the PCV to vacuum didnt you? While the engine is running, pull the pcv from the valve cover. I'll...
I"ll try and remember to get some pics of the setup after I finish getting my tranny back in. Remind me if you don't see anything by Monday.
I used an OFFY 4bbl manifold on my 225. I have the older analog (w/knobs) 2D system. I had to decrease the fuel pressure and play with the TPS...
I really love my Wilwood hyd. It makes the clutch just as soft and smooth as a new Rubicon hyd setup.
I used the Wilwood pull slave and the master cyl. I welded a small bracket of my pedal (hanging pedals) and put the master high up on the...
Separate names with a comma.