1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Search Results

Search Again
  1. jwillys
    Post

    to roll bar or not to roll bar. That is the question.

    Rollbar and seatbelts. Drive defesively and smartly. Then hope for the best.
    Post by: jwillys, Oct 21, 2009 in forum: Flat Fender Tech
  2. jwillys
    Post

    Carburetor, Fuel Pump.......? I'm stumped

    I have a new fuel pump and was told not to use the spacer and have had no problems. Just a thought.
    Post by: jwillys, Sep 30, 2009 in forum: Flat Fender Tech
  3. jwillys
    Post

    Help, need ideas

    I see seats posted on Craigslist here in Phoenix, AZ all the time. Try that.
    Post by: jwillys, Aug 27, 2009 in forum: Flat Fender Tech
  4. jwillys
    Post

    Starter

    I will try that as well, thanks.
    Post by: jwillys, Aug 25, 2009 in forum: Flat Fender Tech
  5. jwillys
    Post

    Starter

    I will take a look, thanks.
    Post by: jwillys, Aug 24, 2009 in forum: Flat Fender Tech
  6. jwillys
    Post

    Starter

    dumb question, but what and where is the ring gear?
    Post by: jwillys, Aug 24, 2009 in forum: Flat Fender Tech
  7. jwillys
    Thread

    Starter

    I have a 52 3A. It has the original starter with the push pedal on the floor. I recently converted to 12 volt. I know that I have to be careful...
    Thread by: jwillys, Aug 24, 2009, 6 replies, in forum: Flat Fender Tech
  8. jwillys
    Post

    Direction for New Project-Opinions

    12 volt is a must imho. I would love to have an overdrive. But other than that do mods as needed or as wanted. I cannot tell you how many times I...
    Post by: jwillys, Aug 10, 2009 in forum: Flat Fender Tech
  9. jwillys
    Thread

    Flat Towing

    Hello all, Any suggestions on flat towing a CJ-5? I have a buddy who has 79 CJ-5 with a 2inch (i think) shackle lift and 32X12.5 in BFG All...
    Thread by: jwillys, Jul 7, 2009, 81 replies, in forum: Early CJ5 and CJ6 Tech
  10. jwillys
    Post

    gas cap

    I have the same issue. I just always try to remember not to top it off.
    Post by: jwillys, Jul 6, 2009 in forum: Flat Fender Tech
  11. jwillys
    Post

    12 volt conversion

    New to the board, but I just did a 12 volt conversion on my 52 3A. Please let me know if you have any questions or run into any problems....
    Post by: jwillys, Jun 25, 2009 in forum: Flat Fender Tech
Showing results 1 to 11 of 11
Search Again
New Posts