Bringing this back up. This is right sector shaft for the V6 and M38-A1 Ross box correct?...
John, I have the factory Crap-loc in my XJ. It's a hand full in the snow in 2-wheel drive but is fine when in 4-wheel drive. Did the locker pretty...
You should be able to get all the 2jet parts from here. I've bought all my stuff from them, except the rebuild kit that I got fron NAPA....
I didn't know that Nick, thanks for posting! Good to know for when we do my Dad's '63.
Yes, those parts will work.
I would replace with a hardened shaft. I also bought new thrust washers. They're cheap and I didn't want to wait for parts after I started the...
Go to your local bearing supplier and buy the cheapest thing they can get. I was able to get some for my D30 setup for like $5-6. Doesn't hurt as...
Those are what I have in my CJ with the relay upgade. They are plenty bright. The Silverstars in my XJ are a little brighter. The only real...
They put 33x12.50's on 8" wheels every day. So I don't see a problem with 10.50's on 6" wheels. I ran 11.50's on 7" wheels for years on my XJ with...
My local Oreilly's Auto parts stocks them.
It's a fairly easy swap. You'll have to adress the spring plates, Mcruff on here makes a nice set of plates with correct hole and shock mount...
Was wondering how this was coming along. Almost time for a Uwharrie shake down run!
That's a good price for around where I'm at, especially if it doesn't need much of a rebuild.
4.5"x 6' @ $6.06. Add it to the cart and price ends up at $36.36. After getting on RA again I see Andrew is right. I was wrong. Sent from my...
They only sell it in packs of 6, so it's actually $36.36. But you'll have 5 spares though! ;)
I'm using a 15" Grant wheel with Ross steering. It's not too bad on the trails with 33's. I wouldn't go any smaller than that though. I'll see if...
Well in my my case Walt, I'm using an EZ-WIre harness so it's wired to a fuse. It does have the circuit breaker on the switch though. After...
Best my memory serves me, drill out the bottom two bellhousing holes and assemble tranny and bell before matting to the engine. Do a search as...
I bought some, but haven't got the paint yet. My JEEP doesn't have the stamped letters at all. The PO replaced the sides at sometime and the...
I'm gonna try one also. Been dealing with the same hesitation here lately. Atleast we are paying a little less now for this flammable water!
Separate names with a comma.