Any one got any tricks for getting front brake drum off a 64 cj5.? I have backed off the adjusters but the wheel is still tight. I can hear...
I have a stupid question : I'm close to eighty and can't see very well, but are the locking nuts on the brake adjusters left handed or right...
Could anyone tell me if the tub width of the 64 and 83 cj5 is the same ? Looking for a windjammer to fit a 64, and only found one to fit an 83....
Trying to find something that will work on a 1964 cj5 to keep the wind off my neck. Does anyone have any suggestions ? I have an old style roll...
After sitting for 3 weeks, my battery died, or so I thought. The digital charger showed "fault". So I go buy a bigger and better battery. After...
Needing to replace starter drive on my 64 cj5. Which brand seems to be the best and worst ? I replaced it around 8 yrs ago with a crown or omix I...
Can someone tell me how long you can leave the key on, without starting the engine before damaging the Petronix module ? Petronix seems not to...
Does anyone know what the first three letters on a f134 distributor mean? Would they relate to the mounting plate configuration? I notice some...
How can I tell the difference ? There is no tag on the distributor and can't find any numbers or letters on it . Its a 64 f134 engine. Is there a...
How much noise do the military ndt tires make on hard surface compared to mud and snow type tires ?
Last week I decided to check the points on LeRoy. Took the cap off, checked the points with feeler gauge and needed to adjust them. Got...
64 Cj5, I need to replace brake pedal arm and probably the shaft as well. I know the best for the arm would be re-bore and bush. The question...
Just put a set of 700-15 military tires on Leroy and wondering how much air pressure you guys run in yours?
What is the best process you folks use when stripping and repainting steel wheels on an early jeep?
1964 cj5 , almost stock. Trying to get fuel gauge on the cluster to work. Replaced the sender unit and checked it with a meter. The generator has...
I have a simple question for you that know: Putting a new rear main seal in my F134 with engine in the vehicle. Removed the old one, no problem....
F134, T90 tran, What would the number one cause of a clutch sticking ? I do have a rear main seal that leaks some. Clutch never slips that I...
Well I got a shock yesterday. Went out to take the jeep for a spin, and the clutch was stuck.. For no known reason. Did a search here and most...
I have a starter condition... This is on an f134, 64 model cj5. The teeth on the starter has ground off about 1/4" from the end. It seems like...
Help me settle a bet with a friend.. I need to replace the valve stem seals on a 64 F134 engine. Have not started yet, but my friend thinks the...
Separate names with a comma.