Awesome...! Yeah as I get older I am now much more conscious of eye wear ear etc. So good good tip there! Not taking them all the way out is also...
While on the subject - any tips/tricks in changing the plugs? Aside from throughout inspection of seat - maybe some light sanding. How do I keep...
Thanks guys!! I was trying not to panic too much but also wanted to address the problem. Appreciate it! Will give it a go after the snow storm....
ah ok - I don't know when - if they were ever replaced!! When I first got the Jeep I brought to mechanic and told em to go through it all....
Hey All. Well I did a search but the bubble issue was only a side part of a past post. So I have a F 134. I just fired her up and noticed bubbles...
Always an education. Thanks for the info. I only had the longer spiral ez out. I was also using a crescent but luckily didn’t push it too far....
Thanks Guys! I guess it wasn't LT 450!! haha. Sat outside for 20 minutes with propane torch. What a PITA this little bastard was. Solid advice...
Thanks! Yeah I think I am past that point. Read somewhere that propane torch would have softened the thread locker - nope... haha Supposedly 400...
So... PO must have put thread locker on the wheel stop - left side Dana 30 - disk break set up. Broke bolt off. heated it, soaked PB Blaster etc....
Thanks! That makes sense. Are the spindle bearings the same for the drum or disk version? Also - are the HUBS interchangeable with the spindles?...
Hey Guys thanks! Framer M - threads r perfect. Its really just the surface is pitted some. Inside diameters look perfect as well. I was thinking...
I see. Thanks Pete. I would rather/need to spend the money elsewhere on the axle. I will take a closer look on the inside, bearing side of the...
Hi All, I have been scrubbing away at these and wanted to find out if they are in usable shape. The spindle to the far left is off of a drum set...
Very interesting guys. Much appreciated!!!
cool thanks!! really appreciate it!
Thanks Daryl! I googled these open knuckles and had not seen the diamond on some of the photos. These actually have the 6 hole disk bracket so...
Hey guys, can anyone guess what year these are? The diamond stamp on the arm has me curious. Thanks!!
haha true...
Hey Guys, Attached is the 2 hole knuckle I inherited with my new Dana 30 I want to refurbish. What do you think? I am planning on a tie rod flip...
So, caliper mounting brackets... I am rebuilding a dana 30 and will be converting it to disks. Its got 10" drums now from a bait and switch from...
Separate names with a comma.