1st a set of rear el Dorado calipers I purchased from ruffstuff specialties a few years ago. These are brand new with park brake arm on the...
I have a brand new DUI distributor for a buick 225 oddfire. I bought this about 15 or so years ago and NEVER used it. Its black and not the...
Selling my 1980 cj dana 300 with the short output shaft. Was freshly rebuilt years ago. I fully suggest going through it again as I dont have the...
Hi all. I'm wondering if there's a cheap master cylinder that fits right onto the 70/71 master cylinder bracket with the stock pedals?
Hi all. Been awhile since I've worked on this Jeep of mine. I have a question about 225 buick and th350 torque converters. I have a stock chevy...
So i've put my combo together and I have the small u-joint on the front. I have not installed it into the frame as of yet, but I'm questioning the...
Will a Scout dana 44 19 spline powerlok fit my 19 spline rear dana 44 in my xx5x cj5? I understand the case break in gears, they are both for 3.92...
I've got a Buick(Dauntless) 225 and I'm looking into getting the FlowKooler water pump to help keep it cool. Looking at getting this one from TA...
well as it turns out I have an m38a1 gas tank. I would love to keep it. Problem is, there is a rust/dirt/corrosion problem going on inside said...
So, I have a choice to make here. My frame has the factory dual master cylinder set-up. Which puts the mc under the floor of the jeep. It is a...
I've got a gm th350 4x4 trans I would like to mount to the 225v6. I know these are not fully bolt up but there are plates out there that will...
I know this has been covered, however it always seems to deter the owner from actually doing this mod to their flat fender. I know there's a...
1st off, I'm very sorry if this has been asked and answered many many, times before. However, I have been searching and racking up a ton of info...
Would a t18 to dana 20 adapter work for adapting a t98a to a large bore dana 18? Or is the rear of the 2 transmissions different?
I need to find a ps pump bracket for my 225. I have found this on ebay....
Been doing a lot of question asking lately, sorry. But I've got another one. I've been looking for possible tilt columns for the little flatty and...
After searching for hours on end, I've come to the conclusion that there are no yj/ wrangler spring swap build up pics. Only pics of the actual...
How odd would the flatty look with a narrowed waggy front axle at 56.5" and a stock 73 rear dana 44 at 50.5"? I know it would be 3" on each side.
Is it safe to run the skinny 1.75" wide springs on a 2.5" wide spring pad? I'm guessing if its ok I would need to run the 2.5" spring plates?
ok Ive been searching and researching the limited slips that are out there for my rear dana 44 30 spline. I have found the trac loks to be junk....
Separate names with a comma.