While I agree that swapping the straight six is a lot of work, I would not say it is impossible. As mentioned elsewhere in this thread, the use of...
Well, after spending about 6 hours tracing each wire in the harness, I was able to get headlights, taillights, brakelights and the turn sugnals to...
The parts jeep vin# is 417xxx. Would there be any way you could scan the wiring harness diagram for under the dash? I have figured out where the...
It is a '70 DJ5A (left hand, normal steering side) with a '73 DJ5C or DJ5D (not exactly sure) wiring harness swapped into it. The harness that...
Short version: Who has installed an aftermarket wiring harness (like the EZ Wiring) in an early Jeep and kept the old 'bus' type NON GM steering...
Is there a reason why the caliper and caliper bracket from the '76- early '78 cj5 d30 w/ 1 1/8" discs cannot be used on a drum-to-disc swap on a...
Nice work. Any chance you will be putting the Commando front clip on it? I have a '70 left hand drive DJ5 that I am converting to 4x4, nice to see...
Re: Ant difference between CJ Dana 30 stub shafts? & brake rotor thickness preference Thanks for the replies. I was hoping I could use the...
I have been collecting a pile of parts for my 1970 left hand drive DJ5 conversion for a while, and this past weekend acquired two CJ Dana 30...
Separate names with a comma.