YOU ARE THE MAN... THANKS!!!!
I have the seats mounted with 3" washers. The seats mount to the tranny tunnel, at the step through of the door, and at the back on the in the...
A few questions to the brain trust please: I have a sport bar which came with my 64 cj5. We started cleaning it up for install but I found 1 side...
Has anyone installed a YJ "fold and tumble" rear seat? I bought factory mounts. Does anyone have measurements for locating in a tub? It looks...
Mine is a 1964. Thanks ALL!!!! I will mount it tomorrow! RR
Could someone give me measurements for the location of the vinyl plate? I replaced the tub and over the past 5 years I have forgotten. Thanks RR
Lines are tight. Checked and rechecked. Rockauto for the carter. Thanks for the replay. RR
Pirate jack said he couldn't help. I explained my title says 1964, the frame and all driveline are 71 with flanged D44 axle with intermediate...
`1971 cj5 configuration with tank at the rear. The battery is fully charged and engine cranks well. I lost all fuel pressure on my F134. I...
I sent a request to pirate jack to see if they have a bolt in solution. The 1974 models on the his website require a mount bracket as well. I...
Hello all: Could someone answer a quick question? I changed my ECJ5 over to the intermediate hanging pedals, 11" brakes and dual master...
Is there anyplace to purchase Kaiser Jeep ID tag for the body? Ours is so chewed up beyond recognition. Thanks Early CJ5 team. Rich
By the way... Anyone have a line on the parking brake lever arm bushing? Mine is nearly gone. Looks like ~3/8" ID x 7/16" OD x maybe 7/16" tall?
I have intermediate pedals on the way. The tub is a 4wd older fiberglass unit. It is already reinforced in the firewall area. I have a YJ clutch...
Can these be used on both sides? Or is it just not necessary on the front from the lack of brake parts?
Thanks Guys. I needed this...
Eugenia the 64 cj5 F134 with T18 is in need of easier clutch actuation and better braking. I am in the process of upgrading to 11" brakes (thanks...
I ordered NHL regulation hockey pucks from Dick's sporting goods today. A 12 pack of A&R pucks was $20. I bought a set of energy poly mounts but...
I am finally to the stage of test fitting the 4wd tub to the chassis. The install kit I purchased from 4wd says for 1976+. After comparing frames...
OK I am a little confused... Are you saying the 10 leaf should be on the passenger or driver side?
Separate names with a comma.