Dose anyone know where I can get a replacement coil for my CRT HEI Distributor? Their website doesn't show anything and they don't answer their...
What is the best locker option for the 1971 Dana 27 front axle? I see Power Tracks makes one but for years up to 1970, what changed in 1971?....
How are you guys routing your exhaust off a 225 header setup? I have mine exiting right under the seats and it’s too loud for me and I would like...
Can anyone recommend and heavy duty Dana 27 Differential Cover, my stock one has taken some direct hits and needs to be replaced. Chip. [ATTACH]
does anyone run a single gas gauge for both the rear and seat tank? I install the gauge and new sending units last year and never finished the...
I have a 1971 Dana 27 front axle, and I was wondering if anyone has done a Tie Rod Flip with these closed knuckles. Thanks, Chip.
on a 1971 CJ-5 with a T98/D18 and D44 rear axle, is the drive line straight (in-line) between the 18 and 44 or is there a small angle? I dont...
Hi guys, I’m having some disturbing noises coming from what appears to be either the D18 transfer case or the warn overdrive at fist I thought it...
I have a freshly rebuilt T18 and everything works ok however every once in awhile it will stick in second gear and it is a real bear to get out....
Over the weekend I ran Slick Rock up at Lake Alpine CA. everything work really good (I recently rebuilt the trans and transfer case) before and on...
I’m having problems with my brakes on my 71 CJ. I have a dual reservoir master cylinder with disks up front and drums on the rear. My problem is...
Finally finished my Transmission / Transfer Case / Over drive rebuild this weekend. All-n-all it wasn’t too bad, started with the transfer case...
does anyone know the oil capacity of the T18 and D18w/overdrive? Thanks, Chip.
anyome know the P/N for the large oil seal for the T-18 Main Shaft? During my rebuild I trashed my old seal and the master rebuild kit from Novak...
Any one have instructions on tearing down and inspection of a T-18 / T-98 Shift Tower? Also, anyone come up with a good reverse switch setup?
I’ve started my T18 transmission teardown and rebuild. Last night I got as far as the teardown process and it looks like I will need a new main...
I’m finishing my D18 transfer case rebuild and I’m installing the double lipped oil seals. I started with the rear output and I installed the new...
What is the correct orientation for the twin stick rattle clips? Also, on sealing the rear spline on the transfer case using RTV do you use...
When rebuilding the t-case do you pack the bearings with grease like a wheel bearing? also, what is a good assembly lube/grease to use? Thanks,...
I'm getting ready to assemble my transfer case this weekend, I've got the Novak rebuild kit with the new inter. shaft, couple of new gears and I'm...
Separate names with a comma.