I found them on Craigslist. I hope that when I get the paint off of them they polish up well. I don't really have anything to put them on other...
Are these factory Renegade wheels? Renegage Wheels7 by sdcj6 posted Aug 1, 2023 at 6:15 PM Renegage Wheels9 by sdcj6 posted Aug 1, 2023 at 6:24 PM...
I have the ring and pinion out of that front axle. It is a 39 ring and 8 pinion gear set. It is also attached to a Power Lok,
Here's my friend's ad on craigslist. Willys Wagon or Pickup Front Differential - auto parts - by owner -... (craigslist.org)
Probably exceeded the weight rating of my trailer. 5.0 Trailer2 by sdcj6 posted Feb 9, 2023 at 10:12 PM 5.0 Trailer1 by sdcj6 posted Feb 9, 2023...
I gave the hitch mount to my friend, cost for the winch was $1.81 per pound! I'm going to mount this one on my CJ-6 and probably sell the Warn...
Brought this one home today. Mounted to a homemade hitch mount that weighs as much as the winch. The blue wiring needs to be replaced. Other than...
Nice power hacksaw!
Does anyone know the correct thickness of the door glass on a Meyers top?
Update on trailer Rims. I finally got the old tires removed and this is what they are mounted to: Trailer Wheel2a by sdcj6 posted May 9, 2022 at...
The transfer case will be a Dana 300 so an adaptor was pretty much a given. It's for a CJ-6, so length is not too big of a concern. I am just...
That's the information I am looking for. I'll take this one back, he also had a Ford T-18-my choice. Thanks guy's
I need a little help on this T-98A. I believe it is from a Jeep 715. How hard to adapt it to a 225 V-6? The input shaft length is about 9.5...
from rensjeep website [IMG]
Are these the square shoulder wheels? Again, from the CJ-2A page [IMG]
From the CJ-2A page Actually that is not entirely correct. There were two military solid disc rims. One was the 4" which was also used on the...
Thanks for the information, how do i determine "square shoulders"?
Ok, Got around to removing it so here are some pictures. Large piece is cast and then rough sanded, surfaces then machined. Small piece if turned...
I will definitely take it apart when i get back, it is hunting season so I will be away for about a week. Pictures when I get back. It seems to...
I kind of does. except it is 2 piece. Look at picture 2, there is a wedge shaped piece next to the timing cover filter flange. No visible bolts...
Separate names with a comma.