Still kicking and Jeeping!
Still breathing and kicking, thanks to God!
I had the same Bike! Bought New in the crate for $2200. Back in 80'! Ran 11.3 at 126 miles per hour in the quarter mile by me! Buried the...
Let's just say that electrical is my bread and butter tell my injury. Both for the Goverment And a big company that starts B. The purity of the...
Guess, I'm the first to say that I love my "Painless wiring harness". Easy install, great instructions and a couple of different models for CJ5s....
That's not the case with mine! The only time I have to shut off the engine to shift, is when I'm stopped, then to go from high to low it will...
Thank's everyone, going to do the wiper linkage today. Should be good to go. Vance.
Thanks tarry99, that all makes sense! Thanks for taking the time to walk me through this. Now, what about the Leather gasket? Does that fit inside...
I have 3 holes in the windshield frame, on the inside. One hole is more "square", the other two are round and you can see where the wiper arm...
Does the flat side face of the linkage face the cabin, or the outside when installed? What about the leathery washers?
This is on my 70' CJ5. Questions on the right way to install wiper linkage. Do you install the wiper shafts into the windshield frame first, then...
Just a thought. On the Summit web site, you can look at the installation PDF.on each of the heaters. The Vintage-air sure is simple and compact!
Maybe a sticky with the recommendations for lubricants would be a good idea?
Thanks timgr, That did help me find the info. Should help for future searching too!
Thanks for the replys. I did buy the gear oil from Nappa, and will change it before driving it again.
I just bought a VintageAir through Summit. The thing I liked over some of the other heaters, I can have it on defrost only, or heat only, or both...
I know this has been asked and answered before, I know I even read the answer I need. Spent over an hour looking for my answer, again, did not...
Tom, just sent you some pics. Rear drive shaft is 12". From front of trans. To output yoke is, 33". No vibrations or trouble so far. You can call...
I have a TH350 behind my 225v6. Love it. Will take pics and send them if you message me your email address. I still don't have the required posts...
Thanks colojeepguy !
Separate names with a comma.