thanks.
hello from reno.. i have a 68 jeepster that i put a late 70's/early 80's 231 even fire buick in.i had the heavy stock flywheel balenced for it...
some one correct me if i'm wrong. but you should be able to use a adjustable proportioning valve and fine tune to your drum/drum.
i'm going to use por15 chassis coat black to go the frame. it says on there web site that most people brush it on. i would like to do that because...
man that is a great looking "5" .that motor looks great.killer stance.good job.
well its christmas night and i thought i would work off some christmas cookies out in the garage. i cut out the stock crossmember and built a new...
if tire clearence is not an issue you can use a box that mounts outside the frame like a scout or blazer.
thanks every one for the info. i spent 2 hours with a tape measure at our local pick and pull junk yard and found some promising stuff. if a...
i had 1.5 inch spacers on my old cj7 for a loooong time ,and never had a problem. i used red loctite and rechecked them every so offten and never...
finished the pedals today. looks the same as before but a lot stronger.i mounted it to the bottom of the dash and the fire wall on the inside and...
what year?
can you guys tell me what radiator's your running in flat fenders with buick v 6's thanks 1. stock 2. custom 3.from a donor 4. other
i bought my kit from novak its made for the buick bell housing
ez wiring makes a great harness .every thing including the wires them selves are marked .makes for a simple install. and about half the cost of...
i only have a 1/2 inch spacer in between yhe tub and frame for mockup , but i will change them for 1 inch poly body mounts befor to long. the...
i think i will be fine. i'm 6'3 260 lbs. so i dont have alot of room to begin with if i need to i can shortin up the trans tunnel a little for a...
re did the front shackle reversal again(the last time) this is the forth time. and i came to the concluesion i had it right the first time. :oops:...
thanks for all the support. i have been busy on the build i will post some pics. tomarrow. got the rock rails started mounted the pedals....
hello ,i'm new to this site .i thought you guys might like this.i'm building a flat fender pick up. frame is a zero rust' 67 jeepster...
Separate names with a comma.