The port in the bottom of this photo is the oil filter bypass correct? It should be held closed by a plunger and spring, correct? [IMG]
After many years of going back and forth between doing this myself or paying someone, I'm finally taking the plunge.:shock: The plan is to get...
For those who have made their own version of the floor mounted pedal (Duffer, Patrick, etc..) What type of hinge did you utilize for the floor...
I'm currently in the process of cleaning up the wiring in the CJ and have come to the conclusion that its time for an accessory fuse block. This...
I'm getting ready to redo my steering setup and have run into a little dilemma. First, the detail of my current setup are as follows: 1973 D30...
I started to tear down my HEI tonight so I could soda blast the housing tomorrow and found this upon teardown. This is a 70's something even fire...
I'm having a little issue trying to source a rebuild kit for my Saginaw steering box. The big problem is that I can't remember what I pulled it...
If all goes well I should be fabbing up a new crossmember this upcoming weekend. I'm installing a SM465 with the 1" Novak Adapter. Currently...
Installing a transmission: 1 - Bolt bellhousing to engine, install transmission 2 - Bolt bellhousing to transmission, install as a unit...
Whats the best way to ream out a pilot bushing .002" or so? I installed a new pilot bushing into the crank, which I believe is .590" ID....
Where can I find replacement head bolts for the :v6:? Don't need ARP or anything special unless they are all that is available.
Fel-Pro 8723 PT-1 head gaskets for the 225. The instructions say that fiber faced gaskets are to be installed dry and thats it, no mention of the...
I've searched a bunch on this topic and most of the threads end up off topic talking about the differences between 225 and 231 rocker arm oiling....
I finally picked up my engine from the machine shop after 2 months. I wasn't planning on having them assemble the short block but they did...
I have my engine completely torn apart and will be taking it to the machine shop next week. The block, crank, and heads are ready to go. I'd...
If all goes well, I should be ready to paint my frame within the next few weeks. Which brings up the next question, what coating to use? My...
Well I picked up one piece of the puzzle today (For the great price of $100) :D [IMG] [IMG] Can anyone identify if this is a BOP...
I'm in the process of replacing my rear wheel bearings and was wondering if the bearing retaining collar comes with the new bearing? The listing...
I'm currently in the middle of replacing the fuel tank, filler hose, vent hose, and supply line on my 71. The vent hose bulkhead fitting that...
Grab a :beer: as this thread is a bit longer than what I normally post Finally received my Edelbrock 7828 timing chain today (what a nightmare...
Separate names with a comma.